HT12A 데이터 시트보기 (PDF) - Holtek Semiconductor

부품명

상세내역

제조사

HT12A

212 Series of Encoders

Holtek Semiconductor 

HT12A/HT12E

Address/Data Waveform

Each programmable address/data pin can be externally set to one of the following two logic states as shown below.

fO S C

"O n e "

"Z e ro "

A d d re s s /

D a ta B it

Address/Data bit waveform for the HT12E

fO S C

D a ta B it

"O n e "

"Z e ro "

A d d r e s s B it

"O n e "

"Z e ro "

D a ta B it

38kH z

c a r r ie r

A d d r e s s B it

Address/Data bit waveform for the HT12A

The address/data bits of the HT12A are transmitted with a 38kHz carrier for infrared remote controller flexibility.

Address/Data Programming (Preset)

The status of each address/data pin can be individually pre-set to logic ²high² or ²low². If a transmission-enable signal

is applied, the encoder scans and transmits the status of the 12 bits of address/data serially in the order A0 to AD11 for

the HT12E encoder and A0 to D11 for the HT12A encoder.

During information transmission these bits are transmitted with a preceding synchronization bit. If the trigger signal is

not applied, the chip enters the standby mode and consumes a reduced current of less than 1mA for a supply voltage of

5V.

Usual applications preset the address pins with individual security codes using DIP switches or PCB wiring, while the

data is selected by push buttons or electronic switches.

The following figure shows an application using the HT12E:

O SC1 O SC2

DOUT

V D D A 0 A 1 A 2 A 3 A 4 A 5 A 6 A 7 V S S TE A D 8 A D 9 A D 10 A D 11

T r a n s m is s io n

m e d iu m

V DD

Rev. 1.20

VSS

6

February 20, 2009

Share Link: