ACPL-333J-500E 데이터 시트보기 (PDF) - Avago Technologies

부품명

상세내역

제조사

ACPL-333J-500E

2.5 Amp Output Current IGBT Gate Driver Optocoupler with Integrated (VCE) Desaturation Detection, UVLO Fault Status Feedback, Active Miller Clamp and Auto-Fault Reset

Avago Technologies 

Regulatory Information

The ACPL-333J is approved by the following organizations:

IEC/EN/DIN EN 60747-5-5

Approval under:

DIN EN 60747-5-5 (VDE 0884-5):2011-11

EN 60747-5-5:2011

UL

Approval under UL 1577, component recognition

program up to VISO = 5000 VRMS. File E55361.

CSA

Approval under CSA Component Acceptance Notice #5,

File CA 88324.

Table 1. IEC/EN/DIN EN 60747-5-5 Insulation Characteristics*

Description

Symbol

Installation classification per DIN VDE 0110/39, Table 1

for rated mains voltage ≤ 150 Vrms

for rated mains voltage ≤ 300 Vrms

for rated mains voltage ≤ 600 Vrms

for rated mains voltage ≤ 1000Vrms

Climatic Classification

Pollution Degree (DIN VDE 0110/39)

Maximum Working Insulation Voltage

VIORM

Input to Output Test Voltage, Method b**,

VPR

VIORM x 1.875=VPR, 100% Production Test with tm=1 sec, Partial discharge < 5 pC

Input to Output Test Voltage, Method a**,

VPR

VIORM x 1.6=VPR, Type and Sample Test, tm=10 sec, Partial discharge < 5 pC

Highest Allowable Overvoltage (Transient Overvoltage tini = 60 sec)

VIOTM

Safety-limiting values – maximum values allowed in the event of a failure.

Case Temperature

TS

Input Current

Output Power

IS, INPUT

PS, OUTPUT

Insulation Resistance at TS, VIO = 500 V

RS

Characteristic

I – IV

I – IV

I – IV

I – III

40/100/21

2

1230

2306

1968

8000

175

400

1200

>109

Unit

Vpeak

Vpeak

Vpeak

Vpeak

°C

mA

mW

Ω

* Isolation characteristics are guaranteed only within the safety maximum ratings which must be ensured by protective circuits in application.

Surface mount classification is class A in accordance with CECCOO802.

** Refer to the optocoupler section of the Isolation and Control Components Designer’s Catalog, under Product Safety Regulations section IEC/EN/

DIN EN 60747-5-5, for a detailed description of Method a and Method b partial discharge test profiles.

Dependence of Safety Limiting Values on Temperature. (take from DS AV01-0579EN Pg.7)

4

Share Link: