ACPL-P480-020E 데이터 시트보기 (PDF) - Avago Technologies

부품명

상세내역

제조사

ACPL-P480-020E

High CMR Intelligent Power Module and Gate Drive Interface Optocoupler

Avago Technologies 

Solder Reflow Profile

Recommended reflow condition as per JEDEC Standard, J-STD-020 (latest revision). Non-Halide Flux should be used.

Regulatory Information

The ACPL-P480 and ACPL-W480 are approved by the following organizations:

IEC/EN/DIN EN 60747-5-5 (Option 60 only)

Approval under:

IEC 60747-5-5 : 2007

EN 60747-5-5 : 2011

DIN EN 60747-5-5 (VDE 0884-5) : 2011-11

CSA

Approval under CSA Component Acceptance Notice #5,

File CA 88324.

UL

ACPL-P480: Approval under UL 1577, component recog-

nition program up to VISO = 3750 VRMS. File E55361.

ACPL-W480 and ACPL-P480 (option 020): Approval under

UL 1577, component recognition program up to VISO =

5000 VRMS. File E55361.

Table 1. IEC/EN/DIN EN 60747-5-5 Insulation Characteristics* (Option 060)

Description

Installation classification per DIN VDE 0110/39, Table 1

for rated mains voltage ≤ 300 Vrms

for rated mains voltage ≤ 450 Vrms

for rated mains voltage ≤ 600 Vrms

Climatic Classification

Pollution Degree (DIN VDE 0110/39)

Maximum Working Insulation Voltage

Input to Output Test Voltage, Method b*

VIORM x 1.875 = VPR, 100% Production Test with tm = 1 sec,

Partial discharge < 5 pC

Input to Output Test Voltage, Method a*

VIORM x 1.6 = VPR, Type and Sample Test with tm = 10 sec,

Partial discharge < 5 pC

Highest Allowable Overvoltage (Transient Overvoltage tini = 60 sec)

Safety-limiting values - maximum values allowed in the event of a failure.

Case Temperature

Input Current

Output Power

Insulation Pesistance at TS, VIO = 500 V

Symbol

VIORM

VPR

VPR

VIOTM

TS

IS,INPUT

PS,OUTPUT

RS

Characteristic

ACPL-P480 ACPL-W480 Unit

I - IV

I - IV

I - III

I - IV

I - III

I - IV

55/100/21

2

891

1140

1670

2137

Vpeak

Vpeak

1426

1824 Vpeak

6000

8000

175

230

600

>109

Vpeak

°C

mA

mW

W

* Refer to the optocoupler section of the Isolation and Control Components Designer’s Catalog, under Product Safety Regulations section, (IEC/EN/

DIN EN 60747-5-5) for a detailed description of Method a and Method b partial discharge test profiles.

4

Share Link: