DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

AD1959 데이터 시트보기 (PDF) - Analog Devices

부품명
상세내역
제조사
AD1959
ADI
Analog Devices ADI
AD1959 Datasheet PDF : 8 Pages
1 2 3 4 5 6 7 8
AD1959
POWER SUPPLY AND VOLTAGE REFERENCE
The AD1959 is designed for five-volt supplies. Separate power
supply pins are provided for the analog, digital, and PLL sec-
tions. These pins should be bypassed with 100 nF ceramic chip
capacitors, as close to the pins as possible, to minimize noise. A
bulk aluminum electrolytic capacitor of at least 22 µF should
also be provided on the same PC board. For best performance it
is recommended that the analog supply be separate from the
digital and PLL supply. It is recommended that all supplies be
isolated by ferrite beads in series with each supply. It is expected
that the digital and PLL sections will be run from a common
supply but isolated from one another. It is important that the
analog supply be as clean as possible.
The internal voltage reference is brought out on Pin 21 (FILTR)
and should be bypassed as close as possible to the chip with a
parallel combination of 10 µF and 100 nF The reference voltage
may be used to bias external op amps to the common-mode
voltage of the analog output signal pins. The current drawn
from the VREF pin should be limited to less than 50 µA.
SERIAL DATA PORTS – DATA FORMAT
The DAC serial data input mode defaults to I2S. By changing
Bits 4 and 5 in the DAC control register, the mode can be
changed to RJ, DSP, or LJ. The word width defaults to 24 bits
but can be changed by programming Bits 8 and 9 in the DAC
Control Register.
Figure 2 shows the serial mode formats.
LRCLK
BCLK
SDATA
MSB
LEFT CHANNEL
RIGHT CHANNEL
LSB
MSB
LEFT-JUSTIFIED MODE – 16 TO 24 BITS PER CHANNEL
LSB
LRCLK
BCLK
SDATA
MSB
LEFT CHANNEL
RIGHT CHANNEL
LSB
MSB
12S MODE – 16 TO 24 BITS PER CHANNEL
LSB
LRCLK
BCLK
SDATA
LEFT CHANNEL
RIGHT CHANNEL
MSB
LSB
MSB
RIGHT-JUSTIFIED MODE – SELECT NUMBER OF BITS PER CHANNEL
LSB
LRCLK
BCLK
SDATA
MSB
LSB
MSB
LSB
DSP MODE – 16 TO 24 BITS PER CHANNEL
1/fS
NOTES
1. DSP MODE DOES NOT IDENTIFY CHANNEL.
2. LRCLK NORMALLY OPERATES AT fS EXCEPT FOR DSP MODE WHICH IS 2 ؋ fS.
3. BCLK FREQUENCY IS NORMALLY 64 ؋ LRCLK BUT MAY BE OPERATED IN BURST MODE.
Figure 2. Stereo Serial Modes
REV. 0
–7–

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]