ADCMP609 데이터 시트보기 (PDF) - Analog Devices

부품명

상세내역

제조사

ADCMP609

Rail-to-Rail, Fast, Low Power 2.5 V to 5.5 V, Single-Supply TTL/CMOS Comparator

Analog Devices 

ADCMP609

With the pin driven low, hysteresis may become large, but in this

device, the effect is not reliable or intended as a latch function.

CROSSOVER BIAS POINT

Rail-to-rail inputs of this type, in both op amps and comparators,

have a dual front-end design. Certain devices are active near

the VCC rail and others are active near the VEE rail. At some pre-

determined point in the common-mode range, a crossover

occurs. At this point, normally VCC/2, the direction of the bias

current reverses and there are changes in measured offset

voltages and currents.

The ADCMP609 slightly elaborates on this scheme. Crossover

points can be found at approximately 0.8 V and 1.6 V.

MINIMUM INPUT SLEW RATE REQUIREMENT

With the rated load capacitance and normal good PC board

design practice (as discussed in the Optimizing Performance

section), these comparators should be stable at any input slew

rate with no hysteresis. Broadband noise from the input stage is

observed in place of the violent chattering seen with most other

high speed comparators. With additional capacitive loading or

poor bypassing, oscillation may be encountered. These oscilla-

tions are due to the high gain bandwidth of the comparator in

combination with feedback through parasitics in the package

and PC board. In many applications, chattering is not harmful.

Rev. 0 | Page 10 of 12

Share Link: