ADL5373-EVALZ_ 데이터 시트보기 (PDF) - Analog Devices

부품명

상세내역

제조사

ADL5373-EVALZ_

F-MOD - 250 MHz to 4000 MHz Quadrature Modulator Family

Analog Devices 

ADL5370/1/2/3/4

EVALUATION BOARD

Populated RoHS-compliant evaluation boards are available for

the F-MOD family (see Ordering Guide for evaluation board

part numbers). Each device has an exposed paddle underneath

the package, which must be soldered to the board. The

evaluation board is designed without any components on the

underside of the board so that heat may be applied to the

underside for easy removal and replacement of the F-MOD.

Preliminary Technical Data

Note that the evaluation board pcb design includes an Enable

Output SMA connector (ENOP) and switch (SW21) which

connect ground or supply to pin 3. Since the F-MOD family

does not support the Enable Output function (pin 3 is a power

supply pin), SW21 should be placed in the ON position. This

connects pin 3 to supply.

Figure 6. Evaluation Board Layout, Top Layer.

Table 4. Evaluation Board Configuration Options

Component

Function

VPOS, GND

Power Supply and Ground Clip Leads

SW21, ENOP SMA Connector

Enable Output Function (not supported in F-Mod family)

RFPI,RFNI,RFPQ,RFNQ,

CFPI, CFNI, CFPQ,CFNQ,

Baseband Input Filters: These components can be used

to implement a low-pass filter for the baseband signals.

RTQ, RTI,

Default Condition

Not applicable

SW21 = ON (connects pin 3 (VPS1) to supply)

RFNQ, RFPQ, RFNI RFPI = 0 Ω (0402)

CFNQ,CFPQ,CFNI,CFPI = Open (0402)

RTQ, RTI = Open (0402)

Rev. PrG | Page 10 of 11

Share Link: