ADP120(RevB) 데이터 시트보기 (PDF) - Analog Devices

부품명

상세내역

제조사

ADP120
(Rev.:RevB)

100 mA, Low Quiescent Current, CMOS Linear Regulator

Analog Devices 

THEORY OF OPERATION

The ADP120 is a low quiescent current, low dropout linear

regulator that operates from 2.3 V to 5.5 V and provides up

to 100 mA of output current. Drawing a low 22 μA of quies-

cent current (typical) at full load makes the ADP120 ideal

for battery-operated portable equipment. Shutdown current

consumption is typically 100 nA.

Optimized for use with small 1 μF ceramic capacitors, the

ADP120 provides excellent transient performance.

VIN

GND

SHORT CIRCUIT,

UVLO, AND

THERMAL

PROTECT

VOUT

R1

EN

SHUTDOWN

0.8V REFERENCE

R2

Figure 27. Internal Block Diagram

ADP120

Internally, the ADP120 consists of a reference, an error amplifier,

a feedback voltage divider, and a PMOS pass transistor. Output

current is delivered via the PMOS pass device, which is controlled

by the error amplifier. The error amplifier compares the reference

voltage with the feedback voltage from the output and amplifies

the difference. If the feedback voltage is lower than the reference

voltage, the gate of the PMOS device is pulled lower, allowing

more current to pass and increasing the output voltage. If the

feedback voltage is higher than the reference voltage, the gate

of the PMOS device is pulled higher, allowing less current to

pass and decreasing the output voltage.

The ADP120 is available in output voltages ranging from 1.2 V

to 3.3 V. The ADP120 uses the EN pin to enable and disable the

VOUT pin under normal operating conditions. When EN is

high, VOUT turns on; when EN is low, VOUT turns off. For

automatic startup, EN can be tied to VIN.

Rev. B | Page 11 of 20

Share Link: