M24128B 데이터 시트보기 (PDF) - STMicroelectronics
부품명
상세내역
제조사
M24128B Datasheet PDF : 19 Pages
| |||
M24256-B, M24128-B
Figure 4. I2C Bus Protocol
SCL
SDA
START
CONDITION
SDA
SDA
INPUT CHANGE
STOP
CONDITION
SCL
SDA
1
2
3
MSB
START
CONDITION
7
8
9
ACK
SCL
1
2
3
7
8
9
SDA
MSB
ACK
STOP
CONDITION
AI00792
cycle) the SDA and SCL lines for a START condi-
tion, and will not respond unless one is given.
Stop Condition
STOP is identified by a low to high transition of the
SDA line while the clock SCL is stable in the high
state. A STOP condition terminates communica-
tion between the memory device and the bus mas-
ter. A STOP condition at the end of a Read
command, after (and only after) a NoAck, forces
the memory device into its standby state. A STOP
condition at the end of a Write command triggers
the internal EEPROM write cycle.
Acknowledge Bit (ACK)
An acknowledge signal is used to indicate a suc-
cessful byte transfer. The bus transmitter, whether
it be master or slave, releases the SDA bus after
sending eight bits of data. During the 9th clock
pulse period, the receiver pulls the SDA bus low to
acknowledge the receipt of the eight data bits.
Data Input
During data input, the memory device samples the
SDA bus signal on the rising edge of the clock,
SCL. For correct device operation, the SDA signal
must be stable during the clock low-to-high transi-
tion, and the data must change only when the SCL
line is low.
Memory Addressing
To start communication between the bus master
and the slave memory, the master must initiate a
START condition. Following this, the master sends
the 8-bit byte, shown in Table 3, on the SDA bus
line (most significant bit first). This consists of the
7-bit Device Select Code, and the 1-bit Read/Write
Designator (RW). The Device Select Code is fur-
ther subdivided into: a 4-bit Device Type Identifier,
and a 3-bit Chip Enable “Address” (E2, E1, E0).
To address the memory array, the 4-bit Device
Type Identifier is 1010b.
4/19
Share Link: 