SP2526EP-2 데이터 시트보기 (PDF) - Signal Processing Technologies

부품명

상세내역

제조사

SP2526EP-2

+3.0V to +5.5V USB Power Control Switch

Signal Processing Technologies 

®

SP2526

+3.0V to +5.5V USB Power Control Switch

s Compliant to USB Specifications

s +3.0V to +5.5V Input Voltage Range

s Two Independent Power Switches

s Two Error Flag Outputs, Open Drain

s 2.7V Undervoltage Lockout

s 500mA Minimum Continuous Load

Current Per Switch

s 1.25A Short Circuit Current Limit

s 140mΩ Maximum On-Resistance

s 80µA On-State Supply Current

s 1µA Shutdown Current

s Output Can Be Forced Higher Than

Input (Off-State)

s Thermal Shutdown

s 1ms Soft-Start Power Up

s Active-High Version: SP2526-1

s Active-Low Version: SP2526-2

DESCRIPTION

The SP2526 device is a dual +3.0V to +5.5V USB Supervisory Power Control Switch ideal for

self-powered and bus-powered Universal Serial Bus (USB) applications. Each switch has low

on-resistance (80mΩ typical) and can supply 500mA minimum. The fault currents are limited

to 2.0A typical and the flag output pin for each switch is available to indicate fault conditions

to the USB controller. The 1ms soft start will eliminate any momentary voltage droop on the

upstream port that may occur when the switch is enabled in bus-powered applications. The

thermal shutdown feature will prevent damage to the device when subjected to excessive

current loads. The undervoltage lockout feature will ensure that the device will remain off

unless there is a valid input voltage present.

ENA 1

FLGA 2

FLGB 3

ENB 4

SP2526

8 OUTA

7 IN

6 GND

5 OUTB

Rev. 9-27-00

SP2526 +3.0V to +5.5V USB Power Control Switch

1

© Copyright 2000 Sipex Corporation

Share Link: