Acknowledge: All addresses and data words are serially transmitted to and from the EEPROM in 8-bit words.
The EEPROM sends a zero to acknowledge that it has received each word. This happens during the ninth clock
cycle.
Figure 7-3. Output Acknowledge
SCL
1
8
9
DATA IN
DATA OUT
Start
Acknowledge
Standby Mode: The AT24CS01/02 features a low-power standby mode which is enabled upon power-up as
well as after the receipt of the Stop condition and the completion of any internal operations.
2-wire Software Reset: After an interruption in protocol, power loss, or system reset, any 2-wire part can be
reset by following these steps:
1. Create a Start condition.
2. Clock nine cycles.
3. Create another Start condition followed by Stop condition as shown in Figure 7-4.
The device is ready for next communication after above steps have been completed.
Figure 7-4. Software reset
Dummy Clock Cycles
SCL
1
2
3
Start
Condition
SDA
8
9
Start
Condition
Stop
Condition
8
AT24CS01/02 [DATASHEET]
Atmel-8815D-SEEPROM-AT24CS01-02-Datasheet_082014