AT90USB128X 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

AT90USB128X

USB DFU Bootloader Datasheet

Atmel Corporation 

Figure 4-1. Example of Firmware Download Zero Length DFU_DNLOAD Request

SETUP

OUT

OUT

OUT

DFU_DNLOAD

Prog_Start + (EP0 fifo length - 6) x 00h

X offset bytes + Firmware Packet 1

Firmware Packet 2

OUT

Firmware Packet n + DFU suffix

IN

ZLP

The Host sends a DFU_DNLOAD request with Zero Length Packet (ZLP) to indicate that it has

completed transferring the firmware image file. This is the final payload packet of a download

operation.

4.6.1.4

Answers from Bootloader

After each program request, the Host can request the device state and status by sending a

DFU_GETSTATUS message.

If the device status indicates an error, the host must send a DFU_CLRSTATUS request to the

device.

4.7 Reading the Flash or EEPROM Data

The flow described below allows the user to read data in the Flash memory or in the EEPROM

data memory. A blank check command on the Flash memory is possible with this flow.

This operation is performed in 2 steps:

• DFU_DNLOAD request with the read command (6 bytes)

• DFU_UPLOAD request which correspond to the previous command.

10

7618C–AVR–07/08

Share Link: