ATA6617 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

ATA6617

Microcontroller with LIN Transceiver, 5V Regulator and Watchdog

Atmel Corporation 

3.3.14 KL_15 Pin

The KL_15 pin is a high-voltage input used to wake up the device from Sleep or Silent Mode.

It is an edge-sensitive pin (low-to-high transition). It is usually connected to ignition to generate

a local wake-up in the application when the ignition is switched on. Although KL_15 pin is at

high voltage (VBatt), it is possible to switch the IC into Sleep or Silent Mode. Connect the

KL_15 pin directly to GND if you do not need it. A debounce timer with a typical TdbKl_15 of

160µs is implemented.

The input voltage threshold can be adjusted by varying the external resistor due to the input

current IKL_15. To protect this pin against voltage transients, a serial resistor of 47 kΩ and a

ceramic capacitor of 100nF are recommended. With this RC combination you can increase the

wake-up time TwKL_15 and, therefore, the sensitivity against transients on the ignition Kl.15.

You can also increase the wake-up time using external capacitors with higher values.

3.3.15

INH Output Pin

The INH Output pin is used to switch an external voltage regulator on during Normal or

Fail-safe Mode. The INH pin is switched off in Sleep or Silent Mode. It is possible to switch off

the external 1kΩ master resistor via the INH pin for master node applications. The INH pin is

switched off during VCC undervoltage reset.

3.3.16

Reset Output Pin (NRES)

The Reset Output pin, an open-drain output, switches to low during VCC undervoltage or a

watchdog failure.

3.3.17

WD_OSC Output Pin

The WD_OSC Output pin provides a typical voltage of 1.2V, which supplies an external resis-

tor with values between 34kΩ and 120kΩ to adjust the watchdog oscillator time.

3.3.18

3.3.19

NTRIG Input Pin

The NTRIG Input pin is the trigger input for the window watchdog. A pull-up resistor is imple-

mented. A negative edge triggers the watchdog. The trigger signal (low) must exceed a

minimum time ttrigmin to generate a watchdog trigger.

Wake-up Events from Sleep or Silent Mode

• LIN-bus

• WAKE pin

• EN pin

• KL_15

8 Atmel ATA6616/ATA6617

9132D–AUTO–12/10

Share Link: