ATA6625 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

ATA6625

LIN Bus Transceiver with Integrated Volt age Regulator

Atmel Corporation 

3.7 Input Pin (TXD)

In Normal Mode the TXD pin is the microcontroller interface to control the state of the LIN output.

TXD must be pulled to ground in order to drive the LIN bus low. If TXD is high or unconnected

(internal pull-up resistor), the LIN output transistor is turned off and the bus is in the recessive

state.

3.8 Dominant Time-out Function (TXD)

The TXD input has an internal pull-up resistor. An internal timer prevents the bus line from being

driven permanently in the dominant state. If TXD is forced to low longer than tDOM > 6 ms, the

LIN bus driver is switched to the recessive state.

To reactivate the LIN bus driver, switch TXD to high (> 10 µs).

3.9 Output Pin (RXD)

This output pin reports the state of the LIN-bus to the microcontroller. LIN high (recessive state)

is reported by a high level at RXD; LIN low (dominant state) is reported by a low level at RXD.

The output has an internal pull-up resistor with typically 5 kΩ to VCC. The AC characteristics are

measured with an external load capacitor of 20 pF.

The output is short-circuit protected. In Unpowered Mode (that is, VS = 0V), RXD is switched off.

3.10

Enable Input Pin (EN)

The Enable Input pin controls the operation mode of the device. If EN is high, the circuit is in

Normal Mode, with transmission paths from TXD to LIN and from LIN to RXD both active. The

VCC voltage regulator operates with 3.3V/5V/50 mA output capability.

If EN is switched to low while TXD is still high, the device is forced to Silent Mode. No data trans-

mission is then possible, and the current consumption is reduced to IVS typ. 57 µA. The VCC

regulator has its full functionality.

If EN is switched to low while TXD is low, the device is forced to Sleep Mode. No data transmis-

sion is possible, and the voltage regulator is switched off.

4 ATA6623/ATA6625

4957H–AUTO–05/10

Share Link: