ATA6625 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

ATA6625

LIN Bus Transceiver with Integrated Volt age Regulator

Atmel Corporation 

4.3 Sleep Mode

A falling edge at EN while TXD is low switches the IC into Sleep Mode. The TXD Signal has to

be logic low during the Mode Select window (Figure 4-4 on page 8). To avoid influencing the

LIN-pin during the switch to sleep mode, it is possible to switch the EN up to 3.2 µs earlier to

LOW than the TXD. Even if the two falling edges at TXD and EN occur at the same time, the LIN

line will remain uninfluenced.

In Sleep Mode the transmission path is disabled. The supply current IVSsleep from VBatt is typically

10 µA. The VCC regulator is switched off, NRES and RXD are low. The internal slave termination

between pin LIN and pin VS is disabled, only a weak pull-up current (typically 10 µA) between

pin LIN and pin VS is present. Sleep Mode can be activated independently from the current level

on pin LIN.

A voltage less than the LIN Pre-wake detection VLINL at pin LIN activates the internal LIN

receiver and switches on the internal slave termination between the LIN pin and the VS pin.

A falling edge at the LIN pin followed by a dominant bus level maintained for a certain time

period (tbus) and a following rising edge at pin LIN results in a remote wake-up request. The

device switches from Sleep Mode to Fail-safe Mode.

The VCC regulator is activated, and the remote wake-up request is indicated by a low level at the

RXD pin to interrupt the microcontroller (Figure 4-5 on page 9).

EN high can be used to switch directly from Sleep to Fail-safe Mode. If EN is still high after VCC

ramp up and undervoltage reset time, the IC switches to Normal Mode.

Figure 4-4. Switch to Sleep Mode

Normal Mode

Sleep Mode

EN

TXD

NRES

Mode select window

td = 3.2 µs

VCC

LIN

Delay time sleep mode

td_sleep = maximum 20 µs

LIN switches directly to recessive mode

8 ATA6623/ATA6625

4957H–AUTO–05/10

Share Link: