CAT1021(2004) 데이터 시트보기 (PDF) - Catalyst Semiconductor => Onsemi

부품명

상세내역

제조사

CAT1021
(Rev.:2004)

Supervisory Circuits with I2C Serial 2k-bit CMOS EEPROM, Manual Reset and Watchdog Timer

Catalyst Semiconductor => Onsemi 

CAT1021, CAT1022, CAT1023

ACKNOWLEDGE

After a successful data transfer, each receiving device

is required to generate an acknowledge. The

acknowledging device pulls down the SDA line during

the ninth clock cycle, signaling that it received the 8 bits

of data.

All devices respond with an acknowledge after receiving

a START condition and its slave address. If the device

has been selected along with a write operation, it

responds with an acknowledge after receiving each 8-

bit byte.

When a device begins a READ mode it transmits 8 bits

of data, releases the SDA line and monitors the line for

an acknowledge. Once it receives this acknowledge, the

device will continue to transmit data. If no acknowledge

is sent by the Master, the device terminates data

transmission and waits for a STOP condition.

WRITE OPERATIONS

Byte Write

In the Byte Write mode, the Master device sends the

START condition and the slave address information (with

the R/W bit set to zero) to the Slave device. After the Slave

generates an acknowledge, the Master sends a 8-bit

address that is to be written into the address pointers of

the device. After receiving another acknowledge from the

Slave, the Master device transmits the data to be written

into the addressed memory location. The device

acknowledges once more and the Master generates the

STOP condition. At this time, the device begins an

internal programming cycle to non-volatile memory. While

the cycle is in progress, the device will not respond to any

request from the Master device.

Figure 5. Start/Stop Timing

SDA

SCL

START BIT

STOP BIT

Figure 6. Acknowledge Timing

SCL FROM

1

MASTER

8

9

DATA OUTPUT

FROM TRANSMITTER

DATA OUTPUT

FROM RECEIVER

START

Figure 7. Slave Address Bits

ACKNOWLEDGE

Default CoCnAfTiguration

1

0

1

00

0

0 R/W

Doc. No. 3009, Rev. K

10

Share Link: