CS61582 데이터 시트보기 (PDF) - Cirrus Logic

부품명

상세내역

제조사

CS61582

Dual T1/E1 Line Interface

Cirrus Logic 

Remote Loopback

A remote loopback is selected by setting the

RLOOP pin high. Selecting RLOOP causes the

data received from the line interface at RTIP and

RRING to be looped back through the jitter at-

tenuator and retransmitted on TTIP and TRING.

Data transmitted at TPOS and TNEG is ignored,

but data recovered from RTIP and RRING con-

tinues to be transmitted on RPOS and RNEG.

Remote loopback is functional if TCLK is ab-

sent. A TAOS request overrides the data

transmitted to the line interface during a remote

loopback. Note that simultaneous selection of lo-

cal and remote loopback modes is not valid.

and receive circuitry is calibrated if REFCLK

and TCLK are present.

JTAG BOUNDARY SCAN

Board testing is supported through JTAG bound-

ary scan. Using boundary scan, the integrity of

the digital paths between devices on a circuit

board can be verified. This verification is sup-

ported by the ability to externally set the signals

on the digital output pins of the CS61582, and to

externally read the signals present on the input

pins of the CS61582. Additionally, the manufac-

turer ID, part number and revision of the

CS61582 can be read during board test using

JTAG boundary scan.

Reset Pin

The CS61582 is continuously calibrated during

operation to insure the performance of the device

over power supply and temperature. This con-

tinuous calibration function eliminates the need

to reset the line interface during operation.

A device reset may be selected by setting the

RESET pin high for a minimum of 200 ns. The

reset function initiates on the falling edge of RE-

SET and requires less than 20 ms to complete.

The control logic is initialized and the transmit

As shown in Figure 9, the JTAG hardware con-

sists of data and instruction registers plus a Test

Access Port (TAP) controller. Control of the TAP

is achieved through signals applied to the Test

Mode Select (J-TMS) and Test Clock ( J-TCK)

input pins. Data is shifted into the registers via

the Test Data Input (J-TDI) pin, and shifted out

of the registers via the Test Data Output (J-TDO)

pin. Both J-TDI and J-TDO are clocked at a rate

determined by J-TCK. The Instruction register

defines which data register is accessed in the

Digital output pins Digital input pins

J-TDI

J-TCK

J-TMS

parallel latched

output

Boundary Scan Data Register

Device ID Data Register

Bypass Data Register

Instruction (shift) Register

parallel latched

output

TAP

Controller

JTAG Block

MUX

J-TDO

Figure 9. Block Diagram of JTAG Circuitry

DS224PP1

13

Share Link: