CT1990 데이터 시트보기 (PDF) - Aeroflex Corporation

부품명

상세내역

제조사

CT1990

MIL-STD-1553B Remote Terminal, Bus Controller, or Passive Monitor Hybrid with Status Word Control

Aeroflex Corporation 

AUTOMATED SELF-TEST

The CT1991 has been designed to fully support a wrap-around self-test which ensures a high degree of fault

coverage. The monolithic circuit includes all circuitry required to perform the self-test.

Self-test can be an on-line or off-line function which is initiated by simple subsystem intervention. The DRVINH

signal selects on-line or off-line testing. The circuit accomplishes the on-line test without accessing the

MIL-STD-1553 data bus by providing an internal data path which connects the encoder circuitry directly to the

decoder circuitry. The transceiver is inhibited during this on-line test. The off-line test is designed to include the

transceiver as well as the protocol device. This mode will generally be useful as an off-line card test where no

live bus is in use.

To initiate the self-test a word is placed in the Vector Word Latch, Loop Test Enable (LTEN) is held low, and the

Loop Test Trigger (LTTRIG) signal is pulsed low. The primary bus will be tested with the word that resides in the

Vector Word Latch, encoded then looped back, decoded and presented to the subsystem as a normal data

transfer would be accomplished. The secondary bus is sequentially tested after the primary bus is completed

via Request Bus A (REQBUSA) utilizing the same word residing in the Vector Word Latch. Upon completion of

each test, pass/fail signals will be asserted reporting the results of the test. This test implementation verifies

MIL-STD-1553 protocol compliance; proper sync character, 16 data bits, Manchester II coding, odd parity,

contiguous word checking and a bit by bit comparison of the transmitted data. The self-test circuitry increases

the fault coverage by insuring that the internal function blocks; encoder, decoder, and internal control circuitry

are operating correctly. An effective data pattern to accomplish this is HEX AA55 since each bit is toggled, (8 bit

internal highway) on a high/low byte basis. The total time required to complete the self-test cycle is 89

microseconds. The Loop Test Enable signal must remain in the low state throughout the diagnostic cycle.

Aeroflex Circuit Technology

9

SCDCT1990 REV B 8/21/00 Plainview NY (516) 694-6700

Share Link: