DS1624 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

제조사

DS1624

Digital Thermometer and Memory

Maxim Integrated 

DS1624 FUNCTIONAL BLOCK DIAGRAM Figure 1

VDD

STATUS REGISTER &

CONTROL LOGIC

DS1624

SCL

SDA

ADDRESS

AND

I/O CONTROL

A0

A1

A2

GND

TEMPERATURE SENSOR

EEPROM MEMORY (256 BYTES)

2-WIRE SERIAL DATA BUS

The DS1624 supports a bi–directional two–wire bus and data transmission protocol. A device that sends

data onto the bus is defined as a transmitter, and a device receiving data as a receiver. The device that

controls the message is called a “master”. The devices that are controlled by the master are “slaves”. The

bus must be controlled by a master device which generates the serial clock (SCL), controls the bus access,

and generates the START and STOP conditions. The DS1624 operates as a slave on the two–wire bus.

Connections to the bus are made via the open–drain I/O lines SDA and SCL. The following bus protocol

has been defined (See Figure 2):

• Data transfer may be initiated only when the bus is not busy.

• During data transfer, the data line must remain stable whenever the clock line is HIGH. Changes in

the data line while the clock line is high will be interpreted as control signals.

Accordingly, the following bus conditions have been defined:

Bus not busy: Both data and clock lines remain HIGH.

Start data transfer: A change in the state of the data line, from HIGH to LOW, while the clock is HIGH,

defines a START condition.

Stop data transfer: A change in the state of the data line, from LOW to HIGH, while the clock line is

HIGH, defines the STOP condition.

3 of 20

Share Link: