EVERLIGHT ELECTRONICS CO.,LTD.
4. Assembly process flow
EHP-A08L/SUR01-P01
Handling Indications:Do not handle the EHP-A08 by the lens at any time during the assembly process.
This can cause damage to the optical surfaces or may dislocate the lens if excessive force is applied.
5. Soldering Iron
i. For prototype builds or small series production runs it is possible to place and solder the LED by
hand.
ii. Dispensing thermal conductive glue or grease on the substrates and follow its curing spec. Press
LED housing to closely connect LED and substrate.
Everlight Electronics Co., Ltd.
Device No. : DSE-8L1-002
http://www.everlight.com
Prepared date: Nov 17, 2006
Rev. 3.0
Page: 10 of 11
Prepared by: Anita Chen