FAN5350 데이터 시트보기 (PDF) - Fairchild Semiconductor

부품명

상세내역

제조사

FAN5350

3MHz, 600mA Step-Down DC-DC Converter in Chip-Scale and MLP Packaging

Fairchild Semiconductor 

PCB Layout Guidelines

For the bill of materials of the FAN5350 evaluation

board, see Table 1. There are only three external

components: the inductor and the input and output

capacitors. For any buck switcher IC, including the

FAN5350, it is always important to place a low-ESR

input capacitor very close to the IC, as shown in Figure

7. That ensures good input decoupling, which helps

reduce the noise appearing at the output terminals and

ensures that the control sections of the IC do not

behave erratically due to excessive noise. This reduces

switching cycle jitter and ensures good overall

performance. It is not considered critical to place either

the inductor or the output capacitor very close to the IC.

There is some flexibility in moving these two

components further away from the IC.

Table 2. FAN5350 Evaluation Board Bill of Materials (optional parts are installed by request only)

Description

Qty.

Ref.

Vendor

Part Number

1.2μH, 1.8A, 55mΩ

Inductor

1.3μH, 1.2A, 90mΩ 1

1.5μH, 1.3A

Capacitor 4.7μF, ±10%, 6.3V, X5R, 0603 2

IC DC/DC Regulator in CSP, 5 bumps

1

Load Resistor (Optional)

1

L1

CIN,COUT

U1

RLOAD

TOKO

FDK

Taiyo Yuden

MURATA

Fairchild

Any

1117AS-1R2M

MIPSA2520D1R0

CBC3225T15MR

GRM39 X5R 475K 6.3

FAN5350UCX

Figure 7. The FAN5350 Evaluation Board PCB (CSP)

Feedback Loop

One key advantage of the non-linear architecture is that

there is no traditional feedback loop. The loop response

to changes in VOUT is essentially instantaneous, which

explains its extraordinary transient response. The

absence of a traditional, high-gain compensated linear

loop means that the FAN5350 is inherently stable over

a wide range of LOUT and COUT.

LOUT can be reduced further for a given application,

provided it is confirmed that the calculated peak current

for the required maximum load current is less than the

minimum of the closed-loop current limit. The

advantage is that this generally leads to improved

transient response, since a small inductance allows for

a much faster increase in current to cope with any

sudden load demand.

The inductor can be increased to 2.2µH; but, for the

same reason, the transient response gets slightly

degraded. In that case, increasing the output capacitor

to 10µF helps significantly.

© 2007 Fairchild Semiconductor Corporation

FAN5350 Rev. 1.0.3

8

www.fairchildsemi.com

Share Link: