GS1501-CQR 데이터 시트보기 (PDF) - Gennum -> Semtech
부품명
상세내역
제조사
GS1501-CQR Datasheet PDF : 15 Pages
| |||
1.2 PIN DESCRIPTIONS (Continued)
PIN NUMBER
NAME
95
FOEN
96
FFRST
TIMING
Non-
synchronous
Synchronous
wrt PCLK_IN
97
WEN
Synchronous
wrt W_CLK
98
REN
Synchronous
wrt PCLK_IN
100
FM_I/E
Non-
synchronous
101
ANC_Y/C
Synchronous
wrt W_CLK
103,104,105,
106, 107, 108,
111, 112, 113,
114
117, 118, 119,
120, 121, 122,
123, 124, 125,
126
DATA_IN [19:10]
(LUMA channel)
Synchronous
wrt PCLK_IN
DATA_IN [9:0]
(CHROMA channel)
Synchronous
wrt PCLK_IN
TYPE
Input
Input
Input
Input
Input
Input
Input
DESCRIPTION
Control Signal Input. Used to enable or disable the FIFO status
flags. When FOEN is low, the FIFO status flags are enabled.
When FOEN is high, the FIFO status flags are disabled.
Control Signal Input. FFRST is used to supply synchronous
reset signals to the FIFO. When FFRST is low, the FIFO is reset
and all internal read and write address pointers are set to their
starting locations.
Control Signal Input. Used to enable or disable writing to the
internal FIFO. When WEN is high, writing to the internal FIFO is
not allowed. Internal write address pointers are stopped at their
current position. WEN is sampled on the rising edge of W_CLK.
When WEN is low, writing to the FIFO is enabled.
Control Signal Input. Used to enable or disable incrementation
of the internal read address pointers. When REN is low, the
internal read address pointers are incremented with each clock
pulse. When REN is high, the internal read address pointers are
stopped at their current position.
Control Signal Input. When FM_I/E is high, the device operates
in a mode where the FIFO reset and read enable signals are
generated internally. In this mode, the device limits the data
insertion to the HANC region of the video stream. The ANC data
to be inserted into the current HANC region are externally
supplied via the FIFO interface during the active video period of
the previous line using the WEN signal. When FM_I/E is low, the
device operates in another mode where the FIFO reset and
read enable signals are generated externally by the user and
supplied to the device via the FFRST and REN control signal
inputs.
Control Signal Input. Used to control insertion of ANC data into
the LUMA or CHROMA FIFO. When ANC_Y/C is high, data
written to the device is placed into the internal LUMA FIFO, or
read into the Luma data stream. When ANC_Y/C is low, data
written to the device is placed into the internal CHROMA FIFO,
or read into the Chroma data stream.
Input Data Bus. LUMA CHANNEL. DATA_IN [19] is the MSB of
the LUMA input signal (pin 103). DATA_IN [10] is the LSB of the
LUMA input signal (pin 114).
Input
CHROMA Input Data Bus. CHROMA CHANNEL DATA_IN [9] is
the MSB of the CHROMA signal (pin 117). DATA_IN [0] is the
LSB of the CHROMA signal (pin 126).
7
GENNUM CORPORATION
52234 - 4
Share Link: 