HI-15530CLT 데이터 시트보기 (PDF) - Holt Integrated Circuits
부품명
상세내역
제조사
HI-15530CLT Datasheet PDF : 13 Pages
| |||
HI-15530
ENCODER OPERATION
The Encoder requires a single clock with a frequency of
twice the desired data rate applied at the SEND CLOCK
input. An auxiliary divide-by-six counter is provided on chip
which can be utilized to produce the SEND CLOCK by
dividing the ENCODER CLOCK.
To abort the Encoder transmission a positive pulse must be
applied at MASTER RESET. Anytime after or during this
pulse, a low to high transition on SEND CLOCK clears the
internal counters and initializes the Encoder for a new
word.
The Encoder's cycle begins when ENCODER ENABLE is
high during a falling edge of ENCODER SHIFT CLOCK (1).
This cycle lasts for one word length or twenty ENCODER
SHIFT CLOCK periods. At the next low-to-high transition of
the ENCODER SHIFT CLOCK, a high at SYNC SELECT
input actuates a command sync or a low will produce a
data sync for that word (2). When the Encoder is ready to
accept data, the SEND DATA output will go high and
remain high for sixteen ENCODER SHIFT CLOCK periods
(3). During these sixteen periods the data should be
clocked into the SERIAL DATA IN input with every low-to-
high transition of the ENCODER SHIFT CLOCK (3) - (4).
After the sync and the Manchester II coded data are
transmitted through the BIPOLAR ONE and BIPOLAR
ZERO outputs, the Encoder adds on an additional bit which
is the parity for that word (5). If ENCODER ENABLE is held
high continuously, consecutive words will be encoded
without an interframe gap. ENCODER ENABLE must go
low by time (5) as shown to prevent a consecutive word
from being encoded. At any time a low on the OUTPUT
INHIBIT input will force both bipolar outputs to a high state
but will not affect the Encoder in any other way.
MASTER RESET
SEND CLK IN
¸ 6 OUT
¸2
¸6
ENCODER CLK
OUTPUT
INHIBIT
BIPOLAR
ONE OUT
Character
Former
BIPOLAR
ZERO OUT
Bit
Counter
SYNC
SELECT
SEND
DATA
ENCODER
SHIFT
CLK
SERIAL
DATA
IN
ENCODER
ENABLE
FIGURE 1. ENCODER
TIMING
SEND CLK
ENCODER
SHIFT CLK
ENCODER
ENABLE
SYNC SELECT
SEND DATA
SERIAL
DATA IN
BIPOLAR
ONE OUT
BIPOLAR
ZERO OUT
01234567
15 16 17 18 19
VALID
DON’T CARE
DON’T CARE
15 14 13 12 11 10
32
1
0
SYNC SYNC 15 14 13 12 11
3
2
1
0
P
SYNC SYNC 15 14 13 12 11
3
2
1
0
P
(1) (2)
(3)
FIGURE 2. ENCODER OPERATION
(4) (5)
HOLT INTEGRATED CIRCUITS
3
Share Link: 