HI-8282ACLT(2001) 데이터 시트보기 (PDF) - Holt Integrated Circuits

부품명

상세내역

제조사

HI-8282ACLT
(Rev.:2001)

ARINC 429 SERIAL TRANSMITTER AND DUAL RECEIVER

Holt Integrated Circuits 

HI-8282A

TRANSMITTER

A block diagram of the transmitter section is shown in Figure 3.

FIFO OPERATION

The FIFO is loaded sequentially by first pulsing PL1 to load byte 1

and then PL2 to load byte 2. The control logic automatically loads

the 31 bit word in the next available position of the FIFO. If TX/R,

the transmitter ready flag is high (FIFO empty), then 8 words,

each 31 bits long, may be loaded. If TX/R is low, then only the

available positions may be loaded. If all 8 positions are full, the

FIFO ignores further attempts to load data.

DATA TRANSMISSION

When ENTX goes high, enabling transmission, the FIFO

positions are incremented with the top register loading into the

data transmission shift register. Within 2.5 data clocks the first

data bit appears at either 429DO or 429DO. The 31 bits in the

data transmission shift register are presented sequentially to the

outputs in the ARINC 429 format with the following timing:

ARINC DATA BIT TIME

DATA BIT TIME

NULL BIT TIME

WORD GAP TIME

HIGH SPEED

10 Clocks

5 Clocks

5 Clocks

40 Clocks

LOW SPEED

80 Clocks

40 Clocks

40 Clocks

320 Clocks

The word counter detects when all loaded positions are

transmitted and sets the transmitter ready flag, TX/R, high.

TRANSMITTER PARITY

The parity generator counts the ONES in the 31-bit word. If the

BD12 control word bit is set low, the 32nd bit transmitted will make

parity odd. If the control bit is high the parity is even.

SELF TEST

If the BD05 control word bit is set low, 429DO or 429DO become

inputs to the receiver bypassing the interface circuitry.

SYSTEMOPERATION

The two receivers are independent of the transmitter. Therefore,

control of data exchanges are strictly at the option of the user. The

only restrictions are:

1. The received data may be overwritten if not retrieved

within one ARINC word cycle.

2. The FIFO can store 8 words maximum and ignores

attempts to load addition data if full.

3. Byte 1 of the transmitter data must be loaded first.

4. Either byte of the received data may be retrieved first.

Both bytes must be retrieved to clear the data ready flag.

5. After ENTX, transmission enable, goes high it cannot go

low until TX/R, transmitter readyflag, goes high. Otherwise,

one ARINC word is lost during transmission.

HOLT INTEGRATED CIRCUITS

5

Share Link: