HT16514-002 데이터 시트보기 (PDF) - Holtek Semiconductor

부품명

상세내역

제조사

HT16514-002

Dot Character VFD Controller & Driver

Holtek Semiconductor 

HT16514

Pin Description

Pin Name I/O

Description

Logic System (Microprocessor Interface)

RS, ST

When parallel mode is selected, this pin is utilized to select the register, either Instruction Reg-

ister or Data Register.

0: IR (Instruction Register)

I 1: DR (Data Register)

When serial mode is selected, this pin performs strobe input. Data can be set as input when

this signal goes 0.

During the next rising edge of this signal, command processing is performed.

E (RD), SCK

When M68 parallel mode is selected (E), this pin is write enable. Writes data at the falling edge.

I When i80 parallel mode is selected (RD), this pin is read enable. When this pin is ²Low², data is

output to the data Bus.

When Serial mode is selected, this pin is shift clock input, data will be written at the rising edge.

CS

I When this pin is ²Low², the device is active.

OSCI

OSCO

I

O

Connected to an external resistor to generate an oscillation frequency.

XOUT

O Oscillator signal output pin

R, W (WR)

When M68 parallel mode is selected (R, W), this pin is data mode select pin

(0: write, 1: read).

I

When i80 parallel mode is selected (WR), this pin is a write enable pin. Data will be written at

rising edge signal.

When serial mode is selected, connect this pin to ²Hi² or ²Low². Read or Write is chosen by in-

struction.

SI, SO

I/O

When serial mode is selected, this pin is used as I/O pin.

When parallel mode is selected, this pin needs to be connected to ²Hi² or ²Low².

DB0~DB7

When parallel mode is selected, these pins are used as I/O pins.

I/O Data are stored sequentially, the first bit which is sent to the HT16514 is MSB.

If 4 bits mode is selected, only DB4~DB7 are used.

RESET

I

Initialize all the internal register and commands.

All segments and digits are fixed PGND.

DS0, DS1

I

Set the duty ratio. Duty ratio will determine the number of grid.

The relationship between duty ratio and these pins is shown in Table 1-1.

Select interface mode (parallel mode or serial mode)

IM

I

0: Serial mode

1: Parallel mode

In parallel mode, instruction will determine the length of word.

MPU

Select interface mode (i80 type CPU mode or M68 type CPU mode)

I 0: i80 type CPU mode

1: M68 type CPU mode

Select number of display line when power ON reset or resetting.

DLS

I 0: Select 1 line (N=0), ²N² is display line select flag in Function set command.

1: Select 2 line (N=1)

RL1, RL2

I Set segment outputs pin assignment. The selection table is listed as Table 1-2 & Table 1-7

TESTI

I

0 or open: Normal operation mode

1: Test mode

TESTO

O For IC testing only, leave this pin open.

Logic System ( To External Extension Driver)

SDO

O Serial data output for extension digit driver.

SLK

O

Shift clock pulse for extension digit driver.

Active during rising edge

Rev. 1.00

3

October 4, 2006

Share Link: