IRPLCFL5E 데이터 시트보기 (PDF) - International Rectifier
부품명
상세내역
제조사
IRPLCFL5E Datasheet PDF : 15 Pages
| |||
IRPLCFL5E
(ZVS) and non-ZVS protection, as well as an integrated bootstrap diode. The IC protects against
non-ZVS by automatically setting the frequency to ensure ZVS. The IC will eventually shut-down if
the non-ZVS condition cannot be achieved.
One of the biggest advantages of the IR2520D is that it incorporates an internal current crest factor
driven shutdown function and it eliminates the need for a high-precision current sensing resistor
that is typically used to detect over current. The IC uses the VS pin and the RDSon of the low-side
half-bridge MOSFET for over-current protection and to detect non-ZVS conditions. An internal 600V
FET connects the VS pin to the VS sensing circuitry and allows for the VS pin to be accurately
measured during the time when pin LO is high, while withstanding the high DC bus voltage during
the other portion of the switching cycle when the high-side FET is turned on and VS is at the DC bus
potential. Please refer to the IR2520D data sheet for further information on the IR2520D including
electrical parameters, state diagram and complete functional description. As a result of the IR2520D
features, the IRPLCFL5E circuit using the IR2520D is a complete CFL solution that offers better
reliability and longer lamp life than self oscillating solutions while reducing component count and
ballast size.
5. Circuit Description
The schematic for IRPLCFL5E is shown in figure 5.1. The BOM with the components values is
shown in table 5.2.
The ballast incorporates a fuse, EMI filter, input rectifier, bus capacitor, half-bridge, control and
output stage. The output stage is the classical resonant circuit consisting of an inductor, LRES, and
a capacitor, CRES. The circuit is built around the IR2520D Ballast Control IC. The IR2520D pro-
vides adjustable preheat time, adjustable run frequency to set the lamp power, high starting fre-
quency (about 2.5 times fmin) to avoid lamp flash, capacitive mode protection for open filament
condition and current crest factor protection for failure to strike or no lamp conditions.
The AC line input voltage is rectified to provide a bus voltage of approximately 300 volts. The start
up resistors, Rsupply1 and Rsupply2, are sized such that they can supply the micro-power current
during under-voltage lockout (UVLO). When VCC exceeds the UVLO+ threshold, the IR2520D
begins to oscillate and the charge pump circuit (CSNUB, DCP1 and DCP2) supplies the current to
VCC that causes the internal 15.6V zener clamp to regulate.
The IR2520D Ballast Control IC controls the frequency of the half-bridge as well as the ballast
states and protection modes such as lamp preheat, lamp ignition, running mode, low AC line
protection and lamp/ballast fault protection.
www.irf.com
3
Share Link: 