Shenzhen KYL Communication Equipment Co., Ltd
As the above picture shows:
Clients can set parameters by KYL-80X software.
1)Module address: From 000 to 255;
2)Channel: Totally eight channels, each channel has different frequency;
3)Transmission interval: It will be in effect only when the module is under point to point
transmitting mode. The minimum transmitting interval is different subject to baud rate
of the module. When setting as “000”, the module works at subordinate mode. It just
takes charge in receiving the output data.
3. How to use the software
1)Connect the module to a PC, open the software KYL-80X, then choose the right port.
2)Electrify, if connect successfully, the software will show “ read success”. Then “read ID”,
read success. You can change the parameter.
Fax: +86-755-83408785
sales02@rf-data.com
www.rf-data.com