LA4460N 데이터 시트보기 (PDF) - SANYO -> Panasonic
부품명
상세내역
제조사
LA4460N Datasheet PDF : 12 Pages
| |||
LA4460N, 4461N
c) Starting time adjustment resistor RX
The purpose of the RX is to adjust the starting time ts, and a resistor of 1.5kΩ is used. In this case, a rising DC locus
as shown below will be obtained at the output terminals.
The circuit has been set to provide signals about 0.4µs. after the power is turned on. Though the ts will increase with
decreasing RX, the total output across the load will be decreased, since the signal flowing to the non-inverted side will
flow into the ground through the RX. Contrarily, increasing the RX to RX=∞ as shown in the Sample Application
Circuit 2, the ts reduces to zero s., and the rising locus as shown below will be obtained.
d) Oscillation compensation CR across the load
To prevent parasitic oscillation, it is recommended to connect 0.033µF plus 4.7Ω between each channel output termi-
nal and GND. (As a rule the capacitor should be a polyester film capacitor.) This measure against the oscillation may
be replaced with the methods as shown below, depending upon the stability of PC boards used.
Note :
· Check for oscillation at low temperatures.
· Check for oscillation on stereo PC boards.
· Do not use shielded wires for output cords.
Note :
· Check for oscillation at low temperatures.
· Use 8Ω load resistor.
· Do not use shielded wires for output cords.
· L should be higher than 0.3µH.
(Removal of oscillation compensation CR)
Coil used
Air core
Inner diameter : 8ø
Number of turns : 6 turns
Wire size : UEW 1.5 Winding method : Solenoid (0.3µH)
Above examples can be applied to the Sample Application Circuits 1, 2.
Features of IC System and Roles of the Remaining Pin Terminals
· Since a zero-bias design is introduced into the input circuit to keep the input potential at about zero by employing PNP
in the input circuit, an input coupling capacitor can be removed for direct connection. However, when noises caused by
a DC current flowing to a volume control circuit or the input circuit causes problems, connect a capacitor in series with
the input circuit.
· To prevent damage or deterioration of the IC due to the load short-circuited, a load short-circuit current limiting type
protection circuit has been provided.
However, when making the load short-circuit test, always mount the IC on the specified heat sink.
· A circuit which prevents pop noise caused by the power on-off operation is also provided, thereby reducing the offset
voltage and protecting speaker systems against damage.
Continued on next page.
No.2660–5/12
Share Link: 