LB11889M 데이터 시트보기 (PDF) - SANYO -> Panasonic

부품명

상세내역

제조사

LB11889M

For VCR Capstan Three-Phase Brushless Motor Driver

SANYO -> Panasonic 

LB11889M

Pin Functions

Pin name

Pin no.

FGIN (-)

3

FGIN (+)

4

FG-OUT

5

CTL

6

CTLREF

7

LIM

8

FC

UIN+, UIN-

VIN+, VIN-

WIN+, WIN-

VCC

VS

ADJ

9

10, 11

12, 13

14, 15

16

21

22

Rf (PWR)

23

Rf (SNS)

31

UOUT

26

VOUT

27

WOUT

28

GSENSE

32

FR

33

GND

34

Functions

Input pin for the FG amplifier to be used with inverted input.

A feedback resistor is connected between this pin and FG OUT.

Noninverting input pin for the FG amplifier to be used as differential input. No bias is applied internally.

FG amplifier output pin with resistive load internally.

Speed control pin. Control is performed by means of constant current drive which is applied by current feedback from Rf.

Gm = 0.65A/V & 1.50A/V TYP at Rf = 0.5Ω

Control reference voltage pin. The voltage is set at approximately VCC/2 internally, but can be varied by applying a

voltage through a low impedance. (The input impedance is approximately 2.5kΩ.)

Current limiter function control pin. This pin voltage is capable of varying the output current linealy.

Slope = 0.5A/V TYP at Rf = 0.5Ω

Speed control loop’s frequency characteristics correction pin.

U phase hall element input pin. “H” for logic represents IN+>IN-.

V phase hall element input pin. “H” for logic represents IN+>IN-.

W phase hall element input pin. “H” for logic represents IN+>IN-.

Power supply pin used to supply to each circuit other than the output blocks inside the IC.

This voltage must be stabilized to reject noise and ripple.

Power supply pin for output blocks.

Pin to be used to adjust the torque ripple correction factor externally.

When adjusting the correction factor, apply voltage externally to the ADJ pin through a low impedance.

Increasing the applied voltage decreases the correction factor ; lowering the applied voltage increases the correction

factor.

The rate of change, when left open, ranges approximately from 0 to 2 times.

(Approximately VCC/2 is set internally and the input impedance is approximately 5kΩ.)

Output current detection pins. Current feedback is provided to the control blocks by connecting Rf between the pins and

GND. The operation of the lower over-saturation prevention circuit and torque ripple correction circuit depends on the pin

voltage.

In particular, since the oversaturation prevention level is set by the pin voltage, decreasing the Rf value extremely may

cause the lower over-saturation prevention to work less efficiently in the large current region. The PWR pin and SENSE

pin must be connected.

U phase output pin

V phase output pin

W phase output pin

(With spark killer diode built in)

GND sensing pin.

By connecting this pin to GND in the vicinity of the Rf resistor side of the Rf included motor GND wiring, the influence

that the GND common impedance exerts on Rf can be excluded. (Must not be left open.)

Forward/reverse select pin.

This pin voltage determines forward/reverse. (Vth = 2.5V typ. At VCC = 5V)

GND for other than output transistors.

The lowest potential of output transistors is on the Rf pin.

No.8791-5/11

Share Link: