LT1206C(Rev0) 데이터 시트보기 (PDF) - Linear Technology
부품명
상세내역
제조사
LT1206C Datasheet PDF : 16 Pages
| |||
LT1206
APPLICATI S I FOR ATIO
For applications where the full bandwidth of the amplifier
is not required, the quiescent current of the device may be
reduced by connecting a resistor from the shutdown pin to
ground. The quiescent current will be approximately 40
times the current in the shutdown pin. The voltage across
the resistor in this condition is V+ – 3VBE. For example, a
60k resistor will set the quiescent supply current to 10mA
with VS = ±15V.
The photos (Figures 4a and 4b) show the effect of reducing
the quiescent supply current on the large-signal response.
The quiescent current can be reduced to 5mA in the
inverting configuration without much change in response.
In noninverting mode, however, the slew rate is reduced
as the quiescent current is reduced.
Slew Rate
Unlike a traditional op amp, the slew rate of a current
feedback amplifier is not independent of the amplifier gain
configuration. There are slew rate limitations in both the
input stage and the output stage. In the inverting mode,
and for higher gains in the noninverting mode, the signal
amplitude on the input pins is small and the overall slew
rate is that of the output stage. The input stage slew rate
is related to the quiescent current and will be reduced as
the supply current is reduced. The output slew rate is set
by the value of the feedback resistors and the internal
capacitance. Larger feedback resistors will reduce the
slew rate as will lower supply voltages, similar to the way
the bandwidth is reduced. The photos (Figures 5a, 5b and
5c) show the large-signal response of the LT1206 for
various gain configurations. The slew rate varies from
860V/µs for a gain of 1, to 1400V/µs for a gain of – 1.
RF = 750Ω IQ = 5mA, 10mA, 20mA
RL = 50Ω VS = ±15V
LT1206 • F04a
Figure 4a. Large-Signal Response vs IQ, AV = –1
RF = 825Ω VS = ±15V
RL = 50Ω
LT1206 • F05a
Figure 5a. Large-Signal Response, AV = 1
RF = 750Ω IQ = 5mA, 10mA, 20mA
RL = 50Ω VS = ±15V
LT1206 • F04b
Figure 4b. Large-Signal Response vs IQ, AV = 2
10
RF = RG = 750Ω VS = ±15V
RL = 50Ω
LT1206 • F05b
Figure 5b. Large-Signal Response, AV = –1
Share Link: 