LT1206(Rev0) 데이터 시트보기 (PDF) - Linear Technology
부품명
상세내역
제조사
LT1206 Datasheet PDF : 16 Pages
| |||
LT1206
APPLICATI S I FOR ATIO
12
10 VS = ±15V
8
RF = 1.2k
COMPENSATION
6
4
2
RF = 2k
NO COMPENSATION
0
–2
RF = 2k
COMPENSATION
–4
–6
–8
1
10
FREQUENCY (MHz)
100
LT1206 • F01
Figure 1.
which is flat to 0.35dB to 30MHz. The network has the
greatest effect for CL in the range of 0pF to 1000pF. The
graph of Maximum Capacitive Load vs Feedback Resistor
can be used to select the appropriate value of feedback
resistor. The values shown are for 0.5dB and 5dB peaking
at a gain of 2 with no resistive load. This is a worst case
condition, as the amplifier is more stable at higher gains
and with some resistive load in parallel with the capaci-
tance. Also shown is the – 3dB bandwidth with the sug-
gested feedback resistor vs the load capacitance.
Although the optional compensation works well with
capacitive loads, it simply reduces the bandwidth when it
is connected with resistive loads. For instance, with a 30Ω
load, the bandwidth drops from 55MHz to 35MHz when
the compensation is connected. Hence, the compensation
was made optional. To disconnect the optional compensa-
tion, leave the COMP pin open.
a 40pF capacitor and the supply current is typically 100µA.
The shutdown pin is referenced to the positive supply
through an internal bias circuit (see the simplified sche-
matic). An easy way to force shutdown is to use open drain
(collector) logic. The circuit shown in Figure 2 uses a
74C904 buffer to interface between 5V logic and the
LT1206. The switching time between the active and shut-
down states is less than 1µs. A 24k pull-up resistor
speeds up the turn-off time and insures that the LT1206
is completely turned off. Because the pin is referenced to
the positive supply, the logic used should have a break-
down voltage of greater than the positive supply voltage.
No other circuitry is necessary as the internal circuit
limits the shutdown pin current to about 500µA. Figure 3
shows the resulting waveforms.
15V
VIN
+
LT1206
– S/D
– 15V
VOUT
RF
ENABLE
5V
74C906
15V
RG
24k
LT1206 • F02
Figure 2. Shutdown Interface
Shutdown/Current Set
If the shutdown feature is not used, the SHUTDOWN pin
must be connected to ground or V –.
The shutdown pin can be used to either turn off the biasing
for the amplifier, reducing the quiescent current to less
than 200µA, or to control the quiescent current in normal
operation.
The total bias current in the LT1206 is controlled by the
current flowing out of the shutdown pin. When the shut-
down pin is open or driven to the positive supply, the part
is shut down. In the shutdown mode, the output looks like
AV = 1
RF = 825Ω
RL = 50Ω
RPU = 24k
VIN = 1VP-P
Figure 3. Shutdown Operation
LT1206 • F3
9
Share Link: 