LV4904V 데이터 시트보기 (PDF) - SANYO -> Panasonic
부품명
상세내역
제조사
LV4904V Datasheet PDF : 25 Pages
| |||
4. Protection Circuits
LV4904V
The LV4904V is provided with under voltage protection circuit, overcurrent protection circuit and thermal protection
circuit.
4.1 Under voltage protection circuit
In order to prevent unstable operation at low voltages, the under voltage protection circuit monitors the PVD pin
voltage, and once the attack voltage (PVD=7V typ.) has been exceeded, it turns on the amplifier. Furthermore, the
recovery voltage (6V typ.) is set so that unstable operation is also prevented when the PVD pin voltage has dropped for
some reason during operation. Since hysteresis of 1V or so is provided between the attack voltage and recovery voltage,
unstable operation near the threshold voltage where the under voltage protection circuit is continuously set to ON and
OFF is prevented. Figure 4.1 shows the operating model of the under voltage protection circuit.
PVD Pin Voltage
Recovery Voltage
Internal
Control
Signal
Figure 4.1 Under voltage protection circuit operation
The circuit is designed to turn the amplifier OFF in the same sequence as when Mute is set to ON so that this can be
used as a measure to prevent pop noise when the primary power for PVD has been turned off.
SANYO Semiconductors’ demonstration board is designed so that the above processes are carried out by the charge
stored in the power supply capacitor (470 µF) that has been added to the primary power supply line.
However, bear in mind that, in the actual products into which this IC has been incorporated, the primary power supply
is connected to other blocks as well, so the time constant for the fall may differ.
No.A1963-13/25
Share Link: 