LV76213A2C 데이터 시트보기 (PDF) - SANYO -> Panasonic
부품명
상세내역
제조사
LV76213A2C
SANYO -> Panasonic
LV76213A2C Datasheet PDF : 44 Pages
| |||
LV76213A2C
Test Conditions at Ta=25°C, ICC=I9=10mA, ICC=I20=11mA, ICC=I49=22mA, VCC=V62= V4=5.0V
Parameter
Symbol
Test
point
Input signal
Test method
[Circuit voltage,current]
Horizontal supply voltage (pin 20)
V20
No signal
20
Apply a current of 13mA to pin 20 and
measure the voltage at pin 20.
Bus conditions
Initial
Logic supply voltage (pin 9)
V9
No signal
9
Apply a current of 11mA to pin 9 and measure Initial
the voltage at pin 9.
RGB supply voltage(pin 49)
I49
No signal
49
Apply a current of 22mA to pin 49 and
measure the voltage (V) at pin49.
Initial
IF supply current(pin 62)
Video / vertical supply current (pin 4)
I62
No signal
62
Apply a voltage of 5.0V to pin 62 and measure Initial
the incoming DC current (mA).
(IF AGC 2.5V applied)
I4
No signal
4
Apply a voltage of 5.0V to pin 4 and measure Initial
the incoming DC current (mA).
• VIF Block Input Signals and Test Conditions
1. Input signals must be input to the PIF IN (pin 56) in the Test Circuit.
2. Input signal voltage values are the levels at the VIF IN (pin 56) in the Test Circuit.
3. Signal contents and signal levels
4. Bus control condition: VIF SYS:”001”, S.TRAP.SW:"1", OVER.MOD.SW:"0", SVO.SW:”0”
Input signal
Waveform
Conditions
SG1
38.9MHz
CW
SG2
34.47MHz
CW
SG3
33.4MHz
CW
SG4
Frequency variable
CW
SG5
38.9MHz
87.5% Video Mod.
10-stairstep wave
(Subcarrier: 4.43MHz)
SG6
38.9MHz
fm=15kHz,AM=78%
SG7
38.9MHz, 90dBu
50IRE
87.5% Video Mod.
50IRE Luma
50IRE Luma
(Carrier: variable)
No.A1937-10/44
Share Link: