M24C16-FCS6TP 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

M24C16-FCS6TP

16Kbit, 8Kbit, 4Kbit, 2Kbit and 1Kbit Serial I²C Bus EEPROM

STMicroelectronics 

Device operation

M24C16, M24C08, M24C04, M24C02, M24C01

3.5

Memory addressing

To start communication between the bus master and the slave device, the bus master must

initiate a Start condition. Following this, the bus master sends the device select code, shown

in Table 3 (on Serial Data (SDA), most significant bit first).

The device select code consists of a 4-bit Device Type Identifier, and a 3-bit Chip Enable

“Address” (E2, E1, E0). To address the memory array, the 4-bit Device Type Identifier is

1010b.

Each device is given a unique 3-bit code on the Chip Enable (E0, E1, E2) inputs. When the

device select code is received, the device only responds if the Chip Enable Address is the

same as the value on the Chip Enable (E0, E1, E2) inputs. However, those devices with

larger memory capacities (the M24C16, M24C08 and M24C04) need more address bits. E0

is not available for use on devices that need to use address line A8; E1 is not available for

devices that need to use address line A9, and E2 is not available for devices that need to

use address line A10 (see Figure 2 and Table 3 for details). Using the E0, E1 and E2 inputs,

up to eight M24C02 (or M24C01), four M24C04, two M24C08 or one M24C16 devices can

be connected to one I²C bus. In each case, and in the hybrid cases, this gives a total

memory capacity of 16 Kbits, 2 KBytes (except where M24C01 devices are used).

The 8th bit is the Read/Write bit (RW). This bit is set to 1 for Read and 0 for Write operations.

If a match occurs on the device select code, the corresponding device gives an

acknowledgment on Serial Data (SDA) during the 9th bit time. If the device does not match

the device select code, it deselects itself from the bus, and goes into Standby mode.

Table 4. Operating modes

Mode

RW bit

Current Address Read

1

0

Random Address Read

1

WC(1)

X

X

X

Sequential Read

1

X

Byte Write

Page Write

1. X = VIH or VIL.

0

VIL

0

VIL

Bytes

Initial sequence

1 Start, Device Select, RW = 1

Start, Device Select, RW = 0, Address

1

reStart, Device Select, RW = 1

≥1

Similar to Current or Random Address

Read

1 Start, Device Select, RW = 0

≤16 Start, Device Select, RW = 0

12/39

Doc ID 5067 Rev 16

Share Link: