M541 데이터 시트보기 (PDF) - Oki Electric Industry

부품명

상세내역

제조사

M541

262,214-Word x 12-Bit Field Memory

Oki Electric Industry 

¡ Semiconductor

MSM5412222

Read Operation

The read operation is controlled by three clocks, SRCK, RSTR, and RE. Read operation is

accomplished by cycling SRCK, and holding RE high after the read address pointer reset

operation or RSTR.

Each read operation, which begins after RSTR, must contain at least 80 active read cycles, i.e.

SRCK cycles while RE is high.

Read Reset : RSTR

The first positive transition of SRCK after RSTR becomes high resets the read address counters

to zero. RSTR setup and hold times are referenced to the rising edge of SRCK. Because the read

reset function is solely controlled by the SRCK rising edge after the high level of RSTR, the states

of RE and OE are ignored in the read reset cycle.

Before RSTR may be brought high again for a further reset operation, it must be low for at least

*two SRCK cycles.

Data Out : DOUT0 - 11

Read Clock : SRCK

Data is shifted out of the data registers. It is triggered by the rising edge of SRCK when RE is high

during a read operation. The SRCK input increments the internal read address pointer when RE

is high.

The three-state output buffer provides direct TTL compatibility ( no pullup resistor required).

Data out is the same polarity as data in. The output becomes valid after the access time interval

tAC that begins with the rising edge of SRCK. *There are no output valid time restriction on

MSM5412222.

Read Enable : RE

The function of RE is to gate of the SRCK clock for incrementing the read pointer. When RE is

high before the rising edge of SRCK, the read pointer is incremented. When RE is low, the read

pointer is not incremented. RE setup times (tRENS and tRDSS) and RE hold times (tRENH and

tRDSH) are referenced to the rising edge of the SRCK clock.

Output Enable : OE

OE is used to enable/disable the outputs. OE high level enables the outputs. The internal read

address pointer is always incremented by cycling SRCK regardless of the OE level. Note that OE

setup and hold times are referenced to the rising edge of SRCK.

6/15

Share Link: