M95160-RMC6P 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

M95160-RMC6P

16-Kbit serial SPI bus EEPROM with high-speed clock

STMicroelectronics 

M95160 M95160-W M95160-R M95160-DF

Instructions

6.5

Read from Memory Array (READ)

As shown in Figure 12, to send this instruction to the device, Chip Select (S) is first driven

low. The bits of the instruction byte and address bytes are then shifted in, on Serial Data

Input (D). The address is loaded into an internal address register, and the byte of data at

that address is shifted out, on Serial Data Output (Q).

Figure 12. Read from Memory Array (READ) sequence

S

0 1 2 3 4 5 6 7 8 9 10 20 21 22 23 24 25 26 27 28 29 30 31

C

Instruction

16-Bit Address

D

15 14 13 3 2 1 0

MSB

High Impedance

Q

Data Out 1

Data Out 2

765432107

MSB

AI01793D

1. Depending on the memory size, as shown in Table 4, the most significant address bits are Don’t Care.

If Chip Select (S) continues to be driven low, the internal address register is incremented

automatically, and the byte of data at the new address is shifted out.

When the highest address is reached, the address counter rolls over to zero, allowing the

Read cycle to be continued indefinitely. The whole memory can, therefore, be read with a

single READ instruction.

The Read cycle is terminated by driving Chip Select (S) high. The rising edge of the Chip

Select (S) signal can occur at any time during the cycle.

The instruction is not accepted, and is not executed, if a Write cycle is currently in progress.

DocID022580 Rev 4

23/47

46

Share Link: