MAX381MJE 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
제조사
MAX381MJE Datasheet PDF : 12 Pages
| |||
Precision, Low-Voltage Analog Switches
______________________________________________________________Pin Description
MAX381
1, 8
PIN
MAX383
1, 3, 6, 8
MAX385
1, 3, 6, 8
NAME
COM_
FUNCTION
Analog Switch Common Terminal
2–7, 12
2, 7, 12
2, 7, 12
N.C.
Not Internally Connected
9, 16
9, 16
4, 5, 9, 16
NO_
Analog Switch Normally Open Terminal
—
4, 5
—
NC_
Analog Switch Normally Closed Terminal
10, 15
10, 15
10, 15
IN_*
Logic Level Input (Normally Low)
11
11
11
V+
Analog Signal and Logic Positive Supply Input
13
13
13
GND
Logic Negative Supply Input (Ground)
14
14
14
V-
Analog Signal Negative Supply Input
* IN1 controls COM1 and COM3; IN2 controls COM2 and COM4.
__________Applications Information
Operation with Supply Voltages
Other than ±5V
The MAX381/MAX383/MAX385 switches operate with
±3.0V to ±8V bipolar supplies and a +3V to +15V single
supply. In either case, analog signals ranging from V+ to
V- can be switched. The Typical Operating Characteristics
graphs show the typical on-resistance variation with ana-
log signal and supply voltage. The usual on-resistance
temperature coefficient is 0.5%/°C (typ).
Overvoltage Protection
Proper power-supply sequencing is recommended for
all CMOS devices. Do not exceed the absolute maxi-
mum ratings, because stresses beyond the listed rat-
ings can cause permanent damage to the devices.
Always sequence V+ on first, then V-, followed by the
logic inputs, NO, or COM. If power-supply sequencing
is not possible, add two small signal diodes (D1, D2) in
series with supply pins for overvoltage protection
(Figure 1). Adding diodes reduces the analog signal
range to one diode drop below V+ and one diode drop
above V-, but does not affect the devices’ low switch
resistance and low leakage characteristics. Device
operation is unchanged, and the difference between
V+ and V- should not exceed 17V. These protection
diodes are not recommended when using a single 3V
supply.
+5V
D1
V+
MAX381
MAX383
MAX385
*
*
COM
NO
*
*
V-
D2
-5V * INTERNAL PROTECTION DIODES
Figure 1. Overvoltage Protection Using Two External Blocking
Diodes
8 _______________________________________________________________________________________
Share Link: 