MAX4524LETB(2007) 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
제조사
MAX4524LETB Datasheet PDF : 12 Pages
| |||
Low-Voltage, Single-Supply Analog
Multiplexers/Switches
ELECTRICAL CHARACTERISTICS—Single +12V Supply (continued)
(V+ = 12V ±5%, GND = 0V, VIH = 2.0V, VIL = 0.8V, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.)
(Notes 2, 3)
PARAMETER
SYMBOL
CONDITIONS
TEMP
MIN TYP MAX UNITS
SWITCH DYNAMIC CHARACTERISTICS
Inhibit Turn-On Time
tON
VNO_= 10V, RL = 300Ω,
CL = 35pF, Figure 1
+25°C
-40°C to +85°C
90
150
ns
200
Inhibit Turn-Off Time
tOFF
VNO_= 10V, RL = 300Ω,
CL = 35pF, Figure 1
+25°C
-40°C to +85°C
40
120
ns
180
Address Transition Time
tTRANS
VNO_= 10V, RL = 300Ω,
CL = 35pF, Figure 2
+25°C
-40°C to +85°C
90
150
ns
200
Break-Before-Make Time
tBBM
VNO = 10V, RL = 300Ω,
CL = 35pF, Figure 3
+25°C
20
ns
Charge Injection
Q
C = 1nF, Figure 4 (Note 7)
+25°C
0.8
pC
NO/NC Off-Capacitance
COM Off-Capacitance
CNO(OFF)
CCOM(OFF)
VNO_ = 0V, ƒ = 1MHz, Figure 5
VNO_ = 0V, ƒ =
1MHz, Figure 5
MAX4524L
MAX4525L
+25°C
+25°C
+25°C
4
pF
14
pF
6
COM On-Capacitance
CCOM(ON)
VNO_ = 0V, ƒ =
1MHz, Figure 5
MAX4524L +25°C
MAX4525L +25°C
20
pF
12
Off-Isolation
VISO
RL = 50Ω, ƒ = 1MHz, Figure 6 +25°C
92
dB
Channel-to-Channel
Crosstalk (MAX4525L)
VCT
RL = 50Ω, ƒ = 1MHz, Figure 6 +25°C
96
dB
On-Channel -3dB
Bandwidth
BW
Figure 6
+25°C
200
MHz
Total Harmonic Distortion
POWER SUPPLY
Power-Supply Range
Power-Supply Current
THD
RL = 600Ω, VCOM = 2.5VP-P,
20Hz to 20kHz BW
+25°C
0.02
%
V+
I+
V+ = 12.6V,
VADD_ = VINH = V+ or 0V
-40°C to +85°C
2
+25°C
-1
-40°C to +85°C -10
12.6
V
+1
µA
+10
Note 2: The TDFN package is production tested at TA = +25°C. Limits over temperature are guaranteed by design.
Note 3: The algebraic convention used in this data sheet is where the most negative value is a minimum column.
Note 4: ∆RON = RON(MAX) - RON(MIN).
Note 5: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal ranges.
Note 6: Leakage parameters are 100% tested at maximum-rated hot operating temperature and guaranteed by design at TA = +25°C.
Note 7: Guaranteed by design, not production tested.
_______________________________________________________________________________________ 3
Share Link: 