MAX4598 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
제조사
MAX4598 Datasheet PDF : 12 Pages
| |||
Low-Voltage, Combination Single-Ended
8-to-1/Differential 4-to-1 Multiplexer
ELECTRICAL CHARACTERISTICS—Single +5V Supply (continued)
(V+ = +5V ±10%, V- = 0, VIH = 2.4V, VIL = 0.8V, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.)
(Note 2)
PARAMETER
SYMBOL
CONDITIONCSONDITIONCSONDITIONS
MIN TYP MAX UNIT
Charge Injection
VCTE
CL = 1nF, VNO_ = 0,
Figure 4
TA = +25°C
1
5
pC
LATCH TIMING (Note 3)
Setup Time
Hold Time
tS
Figure 7
tH
Figure 7
TA = +25°C
TA = TMIN to TMAX
TA = +25°C
TA = TMIN to TMAX
30
70
ns
80
-10
0
ns
-10
ELECTRICAL CHARACTERISTICS—Single +3V Supply
(V+ = +2.7V to +3.6V, V- = 0, VIH = 2.4V, VIL = 0.6V, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.)
PARAMETER
SYMBOL
CONDITIONCSONDITIONCSONDITIONS
MIN TYP MAX UNIT
SWITCH
Analog Signal Range
(Note 3)
0
V+
V
On-Resistance
LOGIC INPUTS (Note 3)
Input High Voltage
Input Low Voltage
DYNAMIC (Note 3)
RON
ICOM_ = 0.2mA,
VNO_ = 1.5V,
V+ = 2.7V
IIH
IIL
TA = +25°C
TA = TMIN to TMAX
220
500
Ω
600
2.4
1.1
V
1.0
0.6
V
Transition Time
tTRANS
VNO1 = 1.5V,
VNO8 = 0, Figure 1
TA = +25°C
200
310
ns
Enable Turn-On Time
tON
VNO1 = 1.5V,
Figure 3
TA = +25°C
160
250
ns
Enable Turn-Off Time
tOFF
VNO1 = 1.5V,
Figure 3
TA = +25°C
120
180
ns
LATCH TIMING (Note 3)
Setup Time
Hold Time
tS
Figure 7
tH
Figure 7
TA = +25°C
TA = +25°C
45
80
ns
-10
0
ns
Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3: Guaranteed by design.
Note 4: ∆RON = RON(MAX) - RON(MIN).
Note 5: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal range.
Note 6: Leakage parameters are 100% tested at maximum-rated hot temperature and guaranteed by correlation at +25°C.
Note 7: Off-Isolation = 20log10(VCOM / VNO), VCOM = output, VNO = input to off switch.
Note 8: Between any two switches.
Note 9: Leakage testing at single supply is guaranteed by testing with dual supplies.
_______________________________________________________________________________________ 5
Share Link: 