MAX4800 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

제조사

MAX4800

Low-Charge Injection, 8-Channel, High-Voltage Analog Switches

Maxim Integrated 

Low-Charge Injection,

8-Channel, High-Voltage Analog Switches

LE

CLK

DIN

DOUT

D7

D6

D5

D4

D3

D2

D1

D0

MSB

LSB

D7

D6

D5

D4

D3

D2

D1

D0

D7

Figure 2. Latch Enable Interface Timing

DATA FROM PREVIOUS DATA BYTE POWER-UP DEFAULT: D7-D0 = 0

When VNN is connected to GND (single-supply applica-

tions), the devices operate with VPP up to +200V. The

VPP and VNN high-voltage supplies are not required to

be symmetrical, but the voltage difference VPP - VNN

must not exceed 200V.

Bleed Resistors (MAX4802)

The MAX4802 features integrated 35kΩ bleed resistors

to discharge capacitive loads such as piezoelectric

transducers. Each analog switch terminal is connected

to RGND with a bleed resistor.

Serial Interface

The MAX4800/MAX4801/MAX4802 are controlled by a

serial interface with an 8-bit serial shift register and

transparent latch. Each of the eight data bits controls a

single analog switch (see Table 1). Data on DIN is

clocked with the most significant bit (MSB) first into the

shift register on the rising edge of CLK. Data is clocked

out of the shift register onto DOUT on the rising edge of

CLK. DOUT reflects the status of DIN, delayed by eight

clock cycles (see Figures 1 and 2).

Latch Enable (LE)

Drive LE logic-low to change the contents of the latch

and update the state of the high-voltage switches

(Figure 2). Drive LE logic-high to freeze the contents of

the latch and prevent changes to the switch states. To

reduce noise due to clock feedthrough, drive LE logic-

high while data is clocked into the shift register. After

the data shift register is loaded with valid data, pulse

LE logic-low to load the contents of the shift register

into the latch.

Latch Clear (CLR)

The MAX4800/MAX4801/MAX4802 feature a latch clear

input. Drive CLR logic-high to reset the contents of the

latch to zero and open all switches. CLR does not

affect the contents of the data shift register. Pulse LE

logic-low to reload the contents of the shift register into

the latch.

Power-On Reset

The MAX4800/MAX4801/MAX4802 feature a power-on

reset circuit to ensure all switches are open at power-

on. The internal 8-bit serial shift register and latch are

set to zero on power-up.

10 ______________________________________________________________________________________

Share Link: