MC100LVEP05 데이터 시트보기 (PDF) - ON Semiconductor
부품명
상세내역
제조사
MC100LVEP05 Datasheet PDF : 10 Pages
| |||
MC100LVEP05
Table 7. 100EP DC CHARACTERISTICS, NECL VCC = 0 V, VEE = −2.375 V to −3.6 V (Note 10)
−40°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
IEE
VOH
VOL
VIH
VIL
VIHCMR
Power Supply Current
15
25
32
17
27
36
19
28
38 mA
Output HIGH Voltage (Note 11)
−1145 −1020 −895 −1145 −1020 −895 −1145 −1020 −895 mV
Output LOW Voltage (Note 11)
−1945 −1770 −1600 −1945 −1770 −1600 −1945 −1770 −1600 mV
Input HIGH Voltage (Single−Ended) −1165
−880 −1165
−880 −1165
−880 mV
Input LOW Voltage (Single−Ended) −1945
−1600 −1945
−1600 −1945
−1600 mV
Input HIGH Voltage Common Mode
VEE+1.2
0.0
VEE+1.2
0.0
VEE+1.2
0.0
V
Range (Differential Configuration)
(Note 12)
IIH
Input HIGH Current
IIL
Input LOW Current
D 0.5
D −150
150
0.5
−150
150
0.5
−150
150 mA
mA
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
10. Input and output parameters vary 1:1 with VCC.
11. All loading with 50 W to VCC − 2.0 V.
12. VIHCMR min varies 1:1 with VEE, VIHCMR max varies 1:1 with VCC. The VIHCMR range is referenced to the most positive side of the differential
input signal.
Table 8. AC CHARACTERISTICS VCC = 0 V; VEE = −2.375 V to −3.6 V or VCC = 2.375 V to 3.6 V; VEE = 0 V (Note 13)
−40°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max
fmax
Maximum Frequency
(Figure 2)
3.0
3.0
3.0
Unit
GHz
tPLH,
tPHL
Propagation Delay to
Output Differential
160 210 260 170 220 270 210 260 320 ps
tJITTER RMS Random Clock Jitter fin v 3.0 GHz
(Figure 2)
0.2
1
0.2
1
0.2 1.5 ps
VPP
Input Voltage Swing (Differential Config- 150 800 1200 150 800 1200 150 800 1200 mV
uration)
tr
Output Rise/Fall Times
tf
(20% − 80%)
Q 70 120 170 80 130 180 100 150 200 ps
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
13. Measured using a 750 mV source, 50% duty cycle clock source. All loading with 50 W to VCC − 2.0 V.
http://onsemi.com
5
Share Link: 