MC10E1651(2002) 데이터 시트보기 (PDF) - ON Semiconductor
부품명
상세내역
제조사
MC10E1651 Datasheet PDF : 12 Pages
| |||
MC10E1651
AC CHARACTERISTICS VCC = +5.0 V ±5%; VEE = –5.2 V ±5% (Note 6)
0°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
fMAX
tPLH
tPHL
Maximum Toggle Frequency
TBD
> 1.0
TBD
GHz
Propagation Delay to Output (Note 7)
ps
V to Q 600 750 900 625 775 925 700 850 1050
LEN to Q 400 575 750 400 575 750 500 650 850
ts
Setup Time V
450 300
450 300
550 350
ps
th
Enable Hold Time V
–50 –250
–50 –250
–100 –250
ps
tpw
Minimum Pulse Width LEN
400
400
400
ps
tskew
Within Device Skew (Note 8)
15
15
15
ps
tJITTER Cycle–to–Cycle Jitter
TBD
TBD
TBD
ps
TDE
Delay Dispersion
ps
(ECL Levels) (Notes 9, 10)
100
(Notes 9, 11)
60
TDL
Delay Dispersion
ps
(TTL Levels) (Notes 12, 13)
350
(Notes 11, 12)
100
tr
Rise/Fall Times
tf
(20-80%)
ps
225 325 475 225 325 475 250 375 500
6. Input and output parameters vary 1:1 with VCC.
7. The propagation delay is measured from the crosspoint of the input signal and the threshold value to the crosspoint of the Q and Q output
signals. For propagation delay measurements the threshold level (VTHR) is centered about an 850mV input logic swing with a slew rate of
0.75 V/NS. There is an insignificant change in the propagation delay over the input common mode range.
8. tskew is the propagation delay skew between comparator A and comparator B for a particular part under identical input conditions.
9. Refer to figure 4 and note that the input is at 850mV ECL levels with the input threshold range between the 20% and 80% points. The delay
is measured from the crosspoint of the input signal and the threshold value to the crosspoint of the Q and Q output signals.
10. The slew rate is 0.25 V/NS for input rising edges.
11. The slew rate is 0.75 V/NS for input rising edges.
12. Refer to Figure 5 and note that the input is at 2.5 V TTL levels with the input threshold range between the 20% and 80% points. The delay
is measured from the crosspoint of the input signal and the threshold value to the crosspoint of the Q and Q output signals.
13. The slew rate is 0.3 V/NS for input rising edges.
http://onsemi.com
4
Share Link: 