MC10E1651FNR2G(2013) 데이터 시트보기 (PDF) - ON Semiconductor
부품명
상세내역
제조사
MC10E1651FNR2G Datasheet PDF : 9 Pages
| |||
MC10E1651
Table 5. AC CHARACTERISTICS VCC = +5.0 V ±5%; VEE = −5.2 V ±5%, GND = 0 V (Note 4)
0°C
25°C
Symbol
Characteristic
Min Typ Max Min Typ Max
fMAX
tPLH
tPHL
Maximum Toggle Frequency
TBD
> 1.0
Propagation Delay to Output (Note 4)
V to Q 750
LEN to Q 550
900 1050 775
725 900 550
925 1075
750 900
ts
th
tpw
tskew
tJITTER
TDE
Setup Time V
450 300
Enable Hold Time V
−50 −250
Minimum Pulse Width LEN
400
Within Device Skew (Note 5)
15
Cycle−to−Cycle Jitter
TBD
Delay Dispersion
(ECL Levels) (Notes 6, 7)
(Notes 6, 8)
450 300
−50 −250
400
15
TBD
100
60
TDL
Delay Dispersion
(TTL Levels) (Notes 9, 10)
350
(Notes 8, 9)
100
tr
Rise/Fall Times
tf
(20-80%)
225 325 475 225 325 475
Min
850
650
550
−100
400
250
85°C
Typ
TBD
1025
825
350
−250
15
TBD
375
Max
1200
1000
500
Unit
GHz
ps
ps
ps
ps
ps
ps
ps
ps
ps
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
4. Input VIL and VIH parameters vary 1:1 with VCC, output VOH and VOL parameters vary 1:1 with GND.
5. tskew is the propagation delay skew between comparator A and comparator B for a particular part under identical input conditions.
6. Refer to figure 4 and note that the input is at 850mV ECL levels with the input threshold range between the 20% and 80% points. The delay
is measured from the crosspoint of the input signal and the threshold value to the crosspoint of the Q and Q output signals.
7. The slew rate is 0.25 V/NS for input rising edges.
8. The slew rate is 0.75 V/NS for input rising edges.
9. Refer to Figure 5 and note that the input is at 2.5 V TTL levels with the input threshold range between the 20% and 80% points. The delay
is measured from the crosspoint of the input signal and the threshold value to the crosspoint of the Q and Q output signals.
10. The slew rate is 0.3 V/NS for input rising edges.
http://onsemi.com
4
Share Link: 