MC10E1651 데이터 시트보기 (PDF) - ON Semiconductor
부품명
상세내역
제조사
MC10E1651 Datasheet PDF : 10 Pages
| |||
MC10E1651
Table 5. AC CHARACTERISTICS VCC = +5.0 V ±5%; VEE = −5.2 V ±5%, VCC = 0 V (Note 4)
0°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
fMAX
tPLH
tPHL
Maximum Toggle Frequency
TBD
> 1.0
TBD
GHz
Propagation Delay to Output (Note 4)
ps
V to Q 750 900 1050 775 925 1075 850 1025 1200
LEN to Q 550 725 900 550 750 900 650 825 1000
ts
Setup Time V
450 300
450 300
550 350
ps
th
Enable Hold Time V
−50 −250
−50 −250
−100 −250
ps
tpw
Minimum Pulse Width LEN
400
400
400
ps
tskew
Within Device Skew (Note 5)
15
15
15
ps
tJITTER Cycle−to−Cycle Jitter
TBD
TBD
TBD
ps
TDE
Delay Dispersion
ps
(ECL Levels) (Notes 6, 7)
100
(Notes 6, 8)
60
TDL
Delay Dispersion
ps
(TTL Levels) (Notes 9, 10)
350
(Notes 8, 9)
100
tr
Rise/Fall Times
tf
(20-80%)
ps
225 325 475 225 325 475 250 375 500
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
4. Input VIL and VIH parameters vary 1:1 with VCC, output VOH and VOL parameters vary 1:1 with GND.
5. tskew is the propagation delay skew between comparator A and comparator B for a particular part under identical input conditions.
6. Refer to figure 4 and note that the input is at 850mV ECL levels with the input threshold range between the 20% and 80% points. The delay
is measured from the crosspoint of the input signal and the threshold value to the crosspoint of the Q and Q output signals.
7. The slew rate is 0.25 V/NS for input rising edges.
8. The slew rate is 0.75 V/NS for input rising edges.
9. Refer to Figure 5 and note that the input is at 2.5 V TTL levels with the input threshold range between the 20% and 80% points. The delay
is measured from the crosspoint of the input signal and the threshold value to the crosspoint of the Q and Q output signals.
10. The slew rate is 0.3 V/NS for input rising edges.
http://onsemi.com
4
Share Link: 