EV2361DQ-00A 데이터 시트보기 (PDF) - Monolithic Power Systems

부품명

상세내역

제조사

EV2361DQ-00A

2A, 23V, 1.4MHz Step-Down Converter

Monolithic Power Systems 

TM

MP2361 – 2A, 23V, 1.4MHz STEP-DOWN CONVERTER

OPERATION

The MP2361 is a current mode regulator. That

is, the COMP pin voltage is proportional to the

peak inductor current. At the beginning of a

cycle: the upper transistor M1 is off; the lower

transistor M2 is on (see Figure 1); the COMP

pin voltage is higher than the current sense

amplifier output; and the current comparator’s

output is low. The rising edge of the 1.4MHz

CLK signal sets the RS Flip-Flop. Its output

turns off M2 and turns on M1 thus connecting

the SW pin and inductor to the input supply.

The increasing inductor current is sensed and

amplified by the Current Sense Amplifier. Ramp

compensation is summed to Current Sense

Amplifier output and compared to the Error

Amplifier output by the Current Comparator.

When the Current Sense Amplifier plus Slope

Compensation signal exceeds the COMP pin

voltage, the RS Flip-Flop is reset and the

MP2361 reverts to its initial M1 off, M2 on state.

If the Current Sense Amplifier plus Slope

Compensation signal does not exceed the

COMP voltage, then the falling edge of the CLK

resets the Flip-Flop.

The output of the Error Amplifier integrates the

voltage difference between the feedback and

the 0.92V bandgap reference. The polarity is

such that the FB pin voltage lower than 0.92V

increases the COMP pin voltage. Since the

COMP pin voltage is proportional to the peak

inductor current an increase in its voltage

increases current delivered to the output. The

lower 10Ω switch ensures that the bootstrap

capacitor voltage is charged during light load

conditions. External Schottky Diode D1 carries

the inductor current when M1 is off.

IN 4

EN 9

INTERNAL

REGULATORS

5V

OSCILLATOR

210KHz/

1.4MHz

SLOPE

COMP

CLK

+

0.7V --

--

SHUTDOWN

COMPARATOR

LOCKOUT

COMPARATOR

CURRENT

SENSE

AMPLIFIER

+

--

+

SQ

RQ

--

CURRENT

COMPARATOR

2.29V/

2.50V

+

+

--

1.8V

FREQUENCY

FOLDBACK

COMPARATOR

-- 0.4V 0.92V

7 FB

SS 10

+ ERROR

AMPLIFIER

8 COMP

Figure 1—Functional Block Diagram

5V

2 BS

5 SW

6 GND

MP2361_BD01

MP2361 Rev. 1.2

www.MonolithicPower.com

4

1/11/2006

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2006 MPS. All Rights Reserved.

Share Link: