SPC5645SF0CLT 데이터 시트보기 (PDF) - Freescale Semiconductor

부품명

상세내역

제조사

SPC5645SF0CLT

Qorivva MPC5645S Microcontroller

Freescale Semiconductor 

— DCULite

— VIU

— 2D Graphics Accelerator (GFX2D)

• Seven slave ports:

— Platform Flash Controller (2 Ports)

— Platform SRAM Controller

— Graphics SRAM Controller (2 Ports)

— QuadSPI serial flash Controller and RLE Decoder

— Peripheral Bridge

• 32-bit internal address bus, 64-bit internal data bus

• Programmable Arbitration Priority

— Requesting masters can be treated with equal priority and will be granted access to a slave port in round-robin

fashion, based upon the ID of the last master to be granted access, or a priority order can be assigned by software

at application run time

• Temporary dynamic priority elevation of masters

1.4.4 Enhanced Direct Memory Access (eDMA)

The eDMA module is a controller capable of performing complex data movements via 16 programmable channels, with

minimal intervention from the host processor. The hardware micro architecture includes a DMA engine which performs source

and destination address calculations, and the actual data movement operations, along with an SRAM-based memory containing

the transfer control descriptors (TCD) for the channels. This implementation is utilized to minimize the overall block size. The

eDMA module provides the following features:

• 16 channels support independent 8-, 16-, or 32-bit single value or block transfers

• Supports variable sized queues and circular queues

• Source and destination address registers are independently configured to post-increment or remain constant

• Each transfer is initiated by a peripheral, CPU, periodic timer interrupt or eDMA channel request

• Each DMA channel can optionally send an interrupt request to the CPU on completion of a single value or block

transfer

• DMA transfers possible between system memories, QuadSPI, RLE Decoder, DSPIs, I2C, ADC, eMIOS, and General

Purpose I/Os (GPIOs)

• Programmable DMA Channel Mux allows assignment of any DMA source to any available DMA channel with up to

a total of 64 potential request sources

1.4.5 Interrupt Controller (INTC)

The INTC (interrupt controller) provides priority-based preemptive scheduling of interrupt requests, suitable for statically

scheduled hard real-time systems.

For high priority interrupt requests, the time from the assertion of the interrupt request from the peripheral to when the processor

is executing the interrupt service routine (ISR) has been minimized. The INTC provides a unique vector for each interrupt

request source for quick determination of which ISR needs to be executed. It also provides an ample number of priorities so that

lower priority ISRs do not delay the execution of higher priority ISRs. To allow the appropriate priorities for each source of

interrupt request, the priority of each interrupt request is software configurable.

When multiple tasks share a resource, coherent accesses to that resource need to be supported. The INTC supports the priority

ceiling protocol for coherent accesses. By providing a modifiable priority mask, the priority can be raised temporarily so that

all tasks which share the resource can not preempt each other.

Qorivva MPC5645S Microcontroller Data Sheet, Rev. 8

10

Freescale Semiconductor

Share Link: