MSM5117805D-60TS-L 데이터 시트보기 (PDF) - Oki Electric Industry

부품명

상세내역

제조사

MSM5117805D-60TS-L

2,097,152-Word x 8-Bit DYNAMIC RAM : FAST PAGE MODE TYPE WITH EDO

Oki Electric Industry 

MSM5117805D

Notes: 1. A start-up delay of 200ms is required after power-up, followed by a minimum of eight

initialization cycles (RAS-only refresh or CAS before RAS refresh) before proper device

operation is achieved.

2. The AC characteristics assume tT = 2ns.

3. VIH (Min.) and VIL (Max.) are reference levels for measuring input timing signals. Transition

times (tT) are measured between VIH and VIL.

4. This parameter is measured with a load circuit equivalent to 2 TTL load and 100pF.

5. Operation within the tRCD (Max.) limit ensures that tRAC (Max.) can be met.

tRCD (Max.) is specified as a reference point only. If tRCD is greater than the specified tRCD (Max.)

limit, then the access time is controlled by tCAC.

6. Operation within the tRAD (Max.) limit ensures that tRAC (Max.) can be met.

tRAD (Max.) is specified as a reference point only. If tRAD is greater than the specified tRAD (Max.)

limit, then the access time is controlled by tAA.

7. tCEZ (Max), tREZ (Max), tWEZ (Max), tOEZ (Max) define the time at which the output achived the

open circuit condition and are not referenced to output voltage levels.

8. tCEZ and tREZ must be satisfied for open circuit condition.

9. tRCH or tRRH must be satisfied for a read cycle.

10. tWCS, tCWD, tRWD, tAWD and tCPWD are not restrictive operating parameters. They are included in the

data sheet as electrical characteristics only. If tWCS ³ tWCS (Min.), then the cycle is an early write

cycle and the data out will remain open circuit (high impedance) throughout the entire cycle. If

tCWD ³ tCWD (Min.), tRWD ³ tRWD(Min.), tAWD ³ tAWD (Min.) and tCPWD ³ tCPWD (Min.), then the cycle

is a read modify write cycle and data out will contain data read from the selected cell; if neither

of the above sets of conditions is satisfied, then the condition of the data out (at access time) is

indeterminate.

11. These parameters are referenced to the CAS leading edge in an early write cycle, and to the WE

leading edge in an OE control write cycle, or a read modify write cycle.

12. The test mode is initiated by performing a WE and CAS before RAS refresh cycle. This mode is

latched and remains in effect until the exit cycle is generated. The test mode specified in this data

sheet is a 2-bit parallel test function. CA9 is not used. In a read cycle, if all internal bits are equal,

the DQ pin will indicate a high level. If any internal bits are not equal, the DQ pin will indicate a

low level. The test mode is cleared and the memory device returned to its normal operating state

by performing a RAS-only refresh cycle or a CAS before RAS refresh cycle.

13. In a test mode read cycle, the value of access time parameters is delayed for 5ns for the specified

value. These parameters should be specified in test mode cycle by adding the above value to the

specified value in this data sheet.

8/14

Share Link: