MSM5412222A 데이터 시트보기 (PDF) - Oki Electric Industry

부품명

상세내역

제조사

MSM5412222A

262,214-Word x 12-Bit Field Memory

Oki Electric Industry 

OKI Semiconductor

MSM5412222A

OPERATION

Write Operation

The write operation is controlled by three clocks, SWCK, RSTW, and WE. Write operation is

accomplished by cycling SWCK, and holding WE high after the write address pointer reset

operation or RSTW.

Each write operation, which begins after RSTW, must contain at least 80 active write cycles,

i.e. SWCK cycles while WE is high. To transfer the last data to the DRAM array, which at that

time is stored in the serial data registers attached to the DRAM array, an RSTW operation is

required after the last SWCK cycle.

Note that every write timing of MSM5412222A is delayed by one clock compared with read

timings for easy cascading without any interface delay devices.

Write Reset : RSTW

The first positive transition of SWCK after RSTW becomes high resets the write address

counters to zero. RSTW setup and hold times are referenced to the rising edge of SWCK.

Because the write reset function is solely controlled by the SWCK rising edge after the high

level of RSTW, the states of WE and IE are ignored in the write reset cycle.

Before RSTW may be brought high again for a further reset operation, it must be low for at

least two SWCK cycles.

Data Inputs : D IN 0 - 11

Write Clock : SWCK

The SWCK latches the input data on chip when WE is high, and also increments the internal

write address pointer. Data-in setup time tDS , and hold time tDH are referenced to the rising

edge of SWCK.

Write Enable : WE

WE is used for data write enable/disable control. WE high level enables the input, and WE

low level disables the input and holds the internal write address pointer. There are no WE

disable time (low) and WE enable time (high) restrictions, because the MSM5412222A is in

fully static operation as long as the power is on. Note that WE setup and hold times are

referenced to the rising edge of SWCK.

Input Enable : IE

IE is used to enable/disable writing into memory. IE high level enables writing. The internal

write address pointer is always incremented by cycling SWCK regardless of the IE level.

Note that IE setup and hold times are referenced to the rising edge of SWCK.

5

Share Link: