MSM9000-XX 데이터 시트보기 (PDF) - Oki Electric Industry
부품명
상세내역
제조사
MSM9000-XX Datasheet PDF : 39 Pages
| |||
¡ Semiconductor
FEDL9000B-01
MSM9000B-xx
LIST OF COMMANDS
No Mnemonics Operation
7
1 LPA
Load Pointer 1
Address
2 LOT
Load Option 1
3
SF
Set Frequency 1
4 BKCG 1/0 Bank Change 1/0 1
5 CONT U/D
Contrast
1
Up/Down
6 STOP
Set
1
Stop Mode
7 SOE/D
Serial Out 1
Enable/Disable
8 DISP Display On/Off 1
9 AINC
Address
1
Increment
10 ABB Arbitrator Blink 1
11 CHB
12 BPC
13 ABLC
Character Blink 0
Blink Pattern 1
Control
Arbitrator Line 0
Change
*: Don't Care
D
6543210
Comments
1 A5 A4 A3 A2 A1 A0 Addresses 0-11, 16-27 for characters and
addresses 32-43, 48-59 for arbitrators
0 1 1 * * I1 I0 Sets additional functions during execution of AINC.
0 1 0 * * F1 F0 Sets conditions on master frequency.
0 0 * 0 0 0 1/0 Valid only in 1/9 duty.
Changes display addresses 0-11, 16-27.
0 0 * 0 0 1 1/0 Adjusts VLCD to 8 stages.
Adjustment range is changed by setting N1 and
N2 pins.
Contrast level is up if D0="1".
Contrast level is down if D0="0".
0 0 * 0 1 0 0 This mode is cancelled if D0="1" irrespective of
either "H" or "L" on C/D.
Stops oscillation and performs operation
equivalent to that of the DISP OFF command.
0 0 * 0 1 1 1/0 Switches between output and high impedance
of SO.
0 0 1/0 1 0 0 1/0 Display is ON if D0="1". Display is OFF if D0=0.
All commons and segments are at VDD level if
display is OFF.
Arbitrators alone are displayed if D4="1".
0 0 * 1 0 1 * Pointer address is incremented by 1.
But, this command is invalid to operations that
are added by setting (I1, I0).
0 0 * 1 1 0 1/0 Data that is input after setting D0="1", is set as data
for arbitrator blink (1-dot unit).
This is cancelled by D0="0".
0 0 * 0 0 1/0 * Controls blinking of character.
0 0 * 1 1 1 1/0 Sets blink patterns of characters.
( : chara) if D0="1", ( : chara) if D0="0".
1 1 * * * L1 L0 Sets arbitrator display lines.
Notes :1 Pointer address is not changed even if commands numbers 1 to 8, 10, 12, 13 are enterd.
:2 Pointer address is automatically incremented by 1 when commands numbers 9, 11,
display code data, and arbitrator data are enterd.
17/39
Share Link: 