MT9171 데이터 시트보기 (PDF) - Zarlink Semiconductor Inc
부품명
상세내역
제조사
MT9171 Datasheet PDF : 28 Pages
| |||
MT9171/72
Data Sheet
extracted and the Receive Interface separates the channels and outputs them to the proper ports in the proper
channel times. The destination of the various channels is the same as that received on the input DV and CD ports.
The Transmit/Receive Timing and Control block generates all the clocks for the transmit and receive functions and
controls the entire chip according to the control register. In order that more than one DNIC may be connected to the
same DV and CD ports an F0o signal is generated which signals the next device in a daisy chain that its channel
times are now active. In this arrangement only the first DNIC in the chain receives the system F0 with the following
devices receiving its predecessor’s F0o.
In MOD mode, all the ports have a different format. The line port again operates at 80 or 160 kbit/s, however, there
is no synchronization overhead, only transparent data. The DV and CD ports carry serial data at 80 or 160 kbit/s
with the DV port transferring all the data for the line and the CD port carrying the C-channel only. In this mode the
transfer of data at both ports is synchronized to the TCK and RCK clocks for transmit and receive data, respectively.
The CLD signal goes low to indicate the start of the C-channel data on the CD port. It is used to load and latch the
input and output C-channel but has no relationship to the data on the DV port.
Operating Modes (MS0-2)
The logic levels present on the mode select pins MS0, MS1 and MS2 program the DNIC for different operating
modes and configure the DV and CD ports accordingly. Table 1 shows the modes corresponding to the state of
MS0-2. These pins select the DNIC to operate as a MASTER or SLAVE, in DUAL or SINGLE port operation, in
MODEM or DIGITAL NETWORK mode and the order of the C and D channels on the CD port. Table 2 provides a
description of each mode and Table 3 gives a pin configuration according to the mode selected for all pins that have
variable functions. These functions vary depending on whether it is in MAS or SLV, and whether DN or MOD mode
is used.
Mode Select Pins
MS2 MS1 MS0
0
0
0
0
0
1
0
1
0
0
1
1
1
0
0
1
0
1
1
1
0
1
1
1
Mode
0
1
2
3
4
5
6
7
Operating Mode
SLV
MAS
DUAL SINGL
MO
D
DN
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
Table 1 - Mode Select Pins
D-C C-D ODE
E
E
X
X
E
E
E
E
E
E
E
X
X
E
E
E
E
E=Enabled X=Not Applicable
Blanks are disabled
8
Zarlink Semiconductor Inc.
Share Link: 