MT9173AN1 데이터 시트보기 (PDF) - Zarlink Semiconductor Inc

부품명

상세내역

제조사

MT9173AN1

ISO2-CMOS ST-BUS™ FAMILY Digital Subscriber Interface Circuit with RxSB Digital Network Interface Circuit with RxSB

Zarlink Semiconductor Inc 

MT9173/74

F0

C4

CDSTo

C0 C1 C2 C3 C4 C5 C6 C7

D0 D1 D2 D3 D4 D5 D6 D7

CDSTi

F0o

C0 C1 C2 C3 C4 C5 C6 C7

D0 D1 D2 D3 D4 D5 D6 D7

3.9 µsec

62.5 µsec

125 µsec

Channel Time 0

Channel Time 16

Figure 7 - CD Port (Modes 2,6)

Data Sheet

C0

C0

CLD

TCK

CDi

C6

C7

C0

C1

C2

C3

C4

C5

C6

C7

C0

C1

CDo

C6

C7

C0

C1

C2

C3

C4

C5

C6

C7

C0

C1

Figure 8 - CD Port (Modes 1,5)

In DIGITAL NETWORK (DN) mode, upon entering the DNIC from the DV and CD ports, the B-channel data, D-

channel D0 (and D1 for 160 kbit/s), the HK bit of the C-channel (160 kbit/s only) and a SYNC bit are combined in a

serial format to be sent out on the line by the Transmit Interface (Figures 11, 12). The SYNC bit produces an

alternating 1-0 pattern each frame in order for the remote end to extract the frame alignment from the line. It is

possible for the remote end to lock on to a data bit pattern which simulates this alternating 1-0 pattern that is not the

true SYNC. To decrease the probability of this happening the DNIC may be programmed to put the data through a

prescrambler that scrambles the data according to a predetermined polynomial with respect to the SYNC bit. This

greatly decreases the probability that the SYNC pattern can be reproduced by any data on the line. In order for the

echo canceller to function correctly, a dedicated scrambler is used with a scrambling algorithm which is different for

the SLV and MAS modes. These algorithms are calculated in such a way as to provide orthogonality between the

near and far end data streams such that the correlation between the two signals is very low.

For any two DNICs on a link, one must be in SLV mode with the other in MAS mode. The scrambled data is

differentially encoded which serves to make the data on the line polarity-independent. It is then biphase encoded as

shown in Figure 10. See “Line Interface” section for more details on the encoding. Before leaving the DNIC the

differentially encoded biphase data is passed through a pulse-shaping bandpass transmit filter that filters out the

high and low frequency components and conditions the signal for transmission on the line.

6

Zarlink Semiconductor Inc.

Share Link: